Parkside PBH 800 B1 handleiding
Handleiding
Je bekijkt pagina 13 van 50
14 GB/IE/NI/CY
1. Grease the SDS-Plus tool holder [] slightly
before inserting the tool.
2. Insert the tool rotatingly into the SDS-Plus tool
holder [] until it clicks into place.
3. Check that the tool is properly locked by
pulling it. The system has radial play because
of the design.
Removing an SDS tool
o Pull the locking collar [9] backwards to remove
the tool.
Selecting operating mode
o Press and hold the release button[6] on
the mode selection knob[7]. Turn the mode
selection knob so that the arrow mark points to
the corresponding symbol.
Symbol Operating mode
Drilling
Hammer drilling
Chiselling
Adjusting chisel position
Adjusting chisel position
In order to rotate the insertion tool to the required
position for chiselling, proceed as follows:
1. Turn the mode selection knob[7] to
(adjusting chisel position).
2. Turn the insertion tool in the SDS-Plus tool
holder[] into the required position.
3. Turn the mode selection knob[7] to
(chiselling).
Setting the rotation direction
NOTE
u Operate the rotation direction switch [1]
only when the product is at a standstill.
o Use the rotation direction switch [1] to change
the direction of rotation of the power tool. This
is not possible while the switch trigger [2] is
pressed down.
o Clockwise: Push the rotation direction
switch[1] to the left as far as possible.
o Anti-clockwise: Push the rotation direction
switch [1] to the right as far as possible.
Switching on/off
o Insert the mains plug[5] into a socket-outlet.
Switching on
o Press the switch trigger [2].
o Do not switch the power tool on unless you
plan to use it, to save energy.
Switching off
o Release the switch trigger [2].
o At low temperatures, the power tool only
reaches its full hammer performance/strike
power after a certain time.
Continuous operation
o Press the switch trigger[2]. At the same time,
press the lock button[3] to lock the switch
trigger.
o To cancel continuous operation, press the
switch trigger [2] briefly and release it.
Adjusting the rotational speed
NOTE
u The switch trigger [2] has a variable speed
control function.
Bekijk gratis de handleiding van Parkside PBH 800 B1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PBH 800 B1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5216 MB |
