Parkside PBH 1550 A1 handleiding
Handleiding
Je bekijkt pagina 11 van 19

11
NI
Inserting /removing the tools
(Fig. C, D)
NOTE!
Ensure that the tool shaft and the tool
holder are free from dust and lightly
grease the shaft using tool insert
lubricant before inserting it into the chuck
18
. This extends the lifetime of the chuck
and the machine.
Suitable for SDS+ system.
• Slide the tool (chisel / drill)
17
into the
tool holder
10
.
• Turn the tool, if necessary in the tool
holder
10
until it audibly clicks into place.
• Check the locking mechanism by gently
pulling the inserted tool.
• To remove the tool, pull the locking sleeve
11
back as far as it goes and pull the tool
out of the tool holder from the front.
• Press and hold the locking latch of the
depth stop
12
on the additional handle
9
.
• Insert the depth stop
15
into the
hexagonal opening provided on the
additional handle above the locking
latch.
• Push the depth stop in the direction of
the hammer drill till the desired depth is
reached.
• Release the locking latch of the depth
stop.
• Check the locking mechanism by gently
pulling the inserted depth stop.
• To readjust the depth stop or to remove it,
proceed in same order.
5. Use
LED display
The hammer drill is provided with an LED
status indicator at the bottom of the vibration-
proof handle
5
.
The two LEDs indicate the following status:
- If the power cord is inserted, the GREEN
LED indicator starts to glow
7
. The
hammer drill is ready for use.
- If the carbon brushes are qorn out, the
RED LED indicator starts to glow
8
. Stop
the work and contact the manufacturer's
customer service department.
Connecting the power
The drill is designed for use with single-
phase AC 230 - 240 V
~
/ 50 Hz and has
protective insulation. Check whether the
mains voltage of the socket corresponds
with the mains voltage indicated on the
rating plate. Use an extension cable if the
work area is not close to the mains outlet.
Ensure an extension cable with sufficient
conductor diameter (min. 1.5 mm²) is used.
If necessary, ask the dealer for advice
when purchasing. The extension cable
used should be as short as possible. Ensure
the mains cable does not pose a tripping
hazard.
Mains cables or the plug may only be
replaced by the manufacturer, or a similarly
qualified person.
The drill is only intended for use with a
continuous current load capacity of the
grid exceeding 100 A per phase and a
distribution grid with a rated voltage of
230-240 V. Make sure that the continuous
current load capacity of the grid at the
connection point with the public grid is
adequate for the drill.
Bekijk gratis de handleiding van Parkside PBH 1550 A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Parkside |
Model | PBH 1550 A1 |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 2661 MB |