Parkside PAMSG 20-Li A1 handleiding
Handleiding
Je bekijkt pagina 13 van 33
GB / IE / NI
|
9
Adapter for dust extraction
Connection
♦ Push the adapter 6 into the adapter
connection 5.
♦ Push the hose from a suitable dust
extraction appliance (e.g. a workshop
vacuum cleaner) onto the adapter6.
Removal
♦ Pull the hose of the dust extractor o
the adapter6.
♦ Pull o the adapter6.
Use
NOTE
► Always switch the appliance on before
making contact with the material, then
apply it to the workpiece.
Switching on and o
Switching the appliance on
♦ Move the ON/OFF switch 2 to the "I"
position.
Switching the appliance o
♦ Move the ON/OFF switch 2 to the "0"
position.
Using the appliance
■ Switch the appliance on before applying
it to the workpiece.
■ Apply minimal pressure when working.
■ Work at a constant speed.
■ Change the sanding sheets regularly.
■ Never use the same sanding sheet for
sanding dierent materials (e.g. wood
followed by metal). Optimum sanding
results can only be achieved by using
clean sanding sheets.
■ Clean the sanding sheet every once in a
while using a vacuum cleaner.
■ Sand hard-to-reach places with the front
or side edge of the sanding sheet on the
sanding plate.
■ Guide the sander over the workpiece
in parallel and use overlapping sanding
motions.
■ After completing the task, lift the appli-
ance from the workpiece and then
switch it o.
Sanding surfaces
♦ Turn on the power tool and ensure that
the whole sanding surface is in contact
with the material being worked. Move it
with moderate pressure over the work-
piece.
NOTE
► The removal rate and the sanding
pattern are mainly determined by the
choice of sanding sheet and the contact
pressure. Only awless sanding sheets
achieve good sanding results.
♦ Ensure that you apply even pressure.
Use of excessive pressure does not
lead to a greater sanding eciency, but
rather to increased wear of the sanding
sheet.
In the table below, you will nd some rec-
ommended values that will help you deter-
mine which sanding sheet3 to use for
which job.
Wood
Sanding
sheet/grain
Working on wood 40 – 240
Pre-sanding of unnished,
unplaned beams and
planks, for example
40, 60
Surface sanding 80, 100, 120
Fine sanding of hardwoods 180, 240
IB_456543_PAEXSG20-LiA1_LB6.indb 9IB_456543_PAEXSG20-LiA1_LB6.indb 9 27.06.2024 08:28:0527.06.2024 08:28:05
Bekijk gratis de handleiding van Parkside PAMSG 20-Li A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PAMSG 20-Li A1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3878 MB |
