Panduit VS2-AVT-3PF-08 handleiding
Handleiding
Je bekijkt pagina 14 van 20
1002985, B21110_EN_rev4 14 10/06/2022
INDICATOR MODULE AND INSTRUCTION LABEL
NOTE: The Instruction Label is UL approved for application to galvanized and stainless steel, ABS, polycarbonate, and polyester paint-
ed surfaces. It is up to the installer to verify proper bond to other surface types.
+
-
Cap
Indicator
Module
Body
Gasket
Battery
Instruction Label
Panel Nut
SYSTEM CABLE
1. Insert the end of the system cable with the right-angle connector in the back of the indicator module. Press firmly into the open-
ing until you feel it latch. Pull back on the connector to verify that it has properly latched.
2. Insert the keyed-end of the system cable into the isolation module port labeled INDICATOR. System cable for an additional indica-
tor (optional) may be inserted into the isolation module port labeled AUX.
The system cable must be separated from the sensor leads and other circuits in the
electrical enclosure by a minimum of 0.25 inches (6 mm).
The maximum allowable system cable length for the INDICATOR port is 30 ft (9.1m).
The maximum allowable system cable length for AUX port is 500 ft (152m).
If the system cable is routed outside of the enclosure that contains the isolation mod-
ule, the system cable must be installed in a conduit. When installed in conduit, the
system cable should be regarded as a data cable and must not use the same conduit as
the electrical power conductors.
Battery Powered Battery Free
BATTERY POWERED INDICATOR MODULE
1. Tighten the panel nut until both it and the
gasket make full contact with the enclosure
surface. Then, tighten an additional 1/4 turn.
2. Install battery into battery tray. The positive
terminal should face the operator. Ensure the
battery is fully seated before proceeding. See
Battery Replacement section for details.
3. Install instruction label near the indicator
module on the exterior of the enclosure.
Mark the label to indicate where in the circuit
the AVT is installed.
4. Install the cap label with the appropriate
language, if other than English.
BATTERY FREE INDICATOR MODULE
1. Tighten the panel nut until both it and the
gasket make full contact with the enclosure
surface. Then, tighten an additional 1/4 turn.
2. Install instruction label near the indicator
module on the exterior of the enclosure.
Mark the label to indicate where in the circuit
the AVT is installed.
3. Install the cap label with the appropriate
language, if other than English.
Indicator
Module
Faceplate
Instruction Label
Indicator
Module
Housing
Panel
Nut
Gasket
Bekijk gratis de handleiding van Panduit VS2-AVT-3PF-08, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Panduit |
| Model | VS2-AVT-3PF-08 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4742 MB |
