Panduit FHSCT handleiding
Handleiding
Je bekijkt pagina 9 van 11
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
FS119A
4. CRIMPING 1.6mm - 2.0mm JACKETED CABLE
Note: Be careful not to break the bare fiber protruding
from the ferrule during this step.
4.1 Flare the aramid yarn evenly around the perimeter of the
grooved area of the backbone of the ferrule assembly. Use
tweezers for best results. There will be a slight gap between
the cable jacket and the backbone.
4.2 Slide the crimp sleeve over the backbone, trapping the aramid
yarn between the crimp sleeve and the grooved area of the
backbone.
4.3 Align the front edge of the crimp sleeve with the front edge of
the crimp die pocket B.
Note: The front edge of the crimp die pocket is the side with
the ribs.
4.4 Making sure the crimp sleeve is seated against the backbone,
crimp the crimp sleeve.
5. CLEAVING 1.6mm - 2.0mm JACKETED CABLE
5.1 Using a carbide scribe to cleave, gently make one small score
mark across the bare fiber just above the endface of the
ferrule. Pull the fiber away from the ferrule and discard it on
one of the sticky tabs provided. A short stub of fiber will
protrude from the tip of the ferrule when viewed through the
FLOUPEX10 Eye Loupe.
5.2 Clean the carbide blade and fingers using a dry lint-free wipe.
This will prevent contamination of the connector during polish-
ing and final assembly.
Page 9 of 11
5.1
1. SCORE
2. PULL FIBER
5.1
4.4
B
A
Crimp die
pocket B
4.2
4.1
Flare aramid
yarn evenly
Gap
Bekijk gratis de handleiding van Panduit FHSCT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Panduit |
| Model | FHSCT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1872 MB |
