Panasonic CY-VMD9000U handleiding
Handleiding
Je bekijkt pagina 4 van 16
E
N
G
L
I
S
H
54
CY-VMD9000U
69
E
N
G
L
I
S
H
53
CY-VMD9000U
68
Installation Guide (Continued)
Mounting the Control Unit
Mounting the Speaker (Supplied)
Removing the Display Unit
❐ Mounting Example
Before mounting the unit, wipe a drop of water, dust
and an oil stain off from the place where the unit
should be mounted to enhance velcro strength.
Stick velcro tape ? on the carpet (underneath the pas-
senger seat, etc.) and mount the control unit on it.
Note:
≥Some carpet materials may not be suitable for this
mounting method. In this case, please contact your
nearest Panasonic Servicenter for installation.
Notes:
≥Never mount the control unit in any of the following locations to avoid damage due to overheating:
• Near the heater port.
• Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
≥Do not mount the control unit near the door, where it could be exposed to rain.
Before mounting the speaker, wipe a drop of water, dust and an oil stain off from the place where the speaker
should be mounted to enhance adhesive strength.
Cautions:
≥Do not install the speaker in a location which obstructs operation of the air bag or other safely equipment.
≥Do not leave a credit card or other magnetic cards near the speakers to avoid damaging the cards.
Push the right and left clamp plates outward, one
at a time, and pull the display unit toward yourself.
Use the supplied spacer = if mounting hole of your car is shaped like below.
Mounting hole of a
bracket (in section)
Bracket
Not used.
Display unit
= Spacer
: Binding-head screw
(M5a6 mm)
Existing bracket (L)
(Bracket originally attached to the car.
The exterior design differs from that of the actual product.)
= Spacer
> Double-faced adhesive tape
> Double-faced adhesive tape
Existing bracket (R)
: Binding-head screw
(M5a6 mm)
Control unit
? Velcro tape
? Velcro tape
Carpet
Speaker (supplied)
≥Cannot be used for a center speaker.
D Double-faced adhesive tape
E Clamp
After removing the right and left clamp plates, pull
the unit with both hands till it comes off.
Push here to remove
the clamp plates.
1
2
Mounting the AV Control Unit with Receiver (CA-TU7000U) or
Multi Channel AV Control Unit with Receiver (CA-TU9000U)
Refer to the operating instructions of the AV control unit with receiver (CA-TU7000U) or multi channel AV con-
trol unit with receiver (CA-TU9000U).
Bekijk gratis de handleiding van Panasonic CY-VMD9000U, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Panasonic |
| Model | CY-VMD9000U |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3269 MB |
