Palmer BRIDGE 4A handleiding
Handleiding
Je bekijkt pagina 9 van 68
9
USER MANUAL
EN
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS - REAR
7. STRAIN RELIEF
Use the strain relief for the flexible cable of the power supply unit of the device to protect the low-voltage power
supply socket and plug from damage and to prevent the plug from being pulled out unintentionally.
8. POWER INPUT
Low-voltage socket for supplying power to the device. To avoid damage to the device, please use only the original
power supply (included in the packaging content).
9. OUTPUT 1 – 4
Balanced line outputs with 3-pin XLR sockets. Use shielded audio cables to connect the Line Isolation Box to a
balanced input of a mixer or audio interface.
10. LIFT / GND 1 OUTPUT 1 - 4 AoC
Switch for disconnecting the ground connection between inputs and outputs (ground lift). In the non-pressed
position, the ground connection is disconnected; the connection is established when the switch is pressed.
The ability to prevent a humming loop using the ground lift switch depends on the grounding of the connected
devices. It is therefore possible that either switch position is able to effectively reduce or eliminate humming.
11. OUTPUT 1 - 4 AoC
Balanced line outputs 1 to 4 with lockable etherCON socket. Separate and analogue transmission of channels
1 to 4 via network cable to a compatible device with an RJ45 socket (cable type Cat5e or better, 4 wire pairs
plus shielding).
NOTES
The line outputs on the front and rear are galvanically isolated from the line inputs.
If several line outputs are used simultaneously on one channel, the signal level may be slightly reduced.
10 11
97 8
Bekijk gratis de handleiding van Palmer BRIDGE 4A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Palmer |
| Model | BRIDGE 4A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10631 MB |
