PAG Mini link MPL150 handleiding
Handleiding
Je bekijkt pagina 15 van 25
15
7. Run-Time, Charge Status & Data Display
7.1 The Battery Display:
The battery is able to display a numeric run-time prediction
against load, and charge status as a percentage.
When connected to a camera that is turned-
on, two presses of the battery’s display
button will show a predicted run-time
against the given load, expressed in hours
and minutes.
When batteries are linked the run-time displayed relates to the
total for the connected batteries. 3 button presses will keep the
run-time information on display until the camera is turned-off, or
until you press the display button again. If the predicted run-time
is more than 9hrs 59mins, the display will not provide a figure.
A single button press of the display, off or
on-load, shows individual battery state of
charge as a percentage, even when it is
linked.
When individual battery SoC drops below
5% the display will indicate that the battery
should be charged, as shown.
7.2 Display Data Output:
Data stored in the battery’s microprocessor can be revealed using
the battery display:
Press display button
x3 in 1 sec intervals &
hold for data mode
Release to see 1st
menu item: ‘Pd’
(voltage)
Press & hold for
3 seconds to see
voltage reading
Press without holding
for 2nd menu item
Press & hold for temp-
erature in degrees
celsius
Press twice
without holding
for 3rd menu item
Press & hold for
number of charge/
discharge cycles
Bekijk gratis de handleiding van PAG Mini link MPL150, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | PAG |
| Model | Mini link MPL150 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2875 MB |
