PAC TY1A-RS handleiding

Handleiding

1234567/ 7

Afdrukken

Je bekijkt pagina 6 van 7

Radio Replacement and

Steering Wheel Control Interface

for Toyota / Lexus / Scion Vehicles

TY1A-RS

© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.

PAC-audio.com

Pacific Accessory Corporation

Page 6

Rev: V4

Date:090519

1. Turn the ignition on. The LED on the interface will turn on and the +12v accessory wire will turn on.

2. Turn on the radio and check volume, balance and fade.If you do not hear any audio you may need to cycle the ignition to

initialize the factory amplier.

3. If the overall volume is too low, use the gain adjustment on the side of the TY1A-RS interface to set it to the desired level.

The best way to do this is to turn the volume on the radio to 3/4 volume, then turn the gain on the TY1A-RS until some

distortion is heard, then back it down a little.

4. If you have a JBL system and there is no audio, please make sure the Blue / White wire in the radio connector is hooked up

properly. If there is still no audio, reset the interface according to the procedure in the next section.

5. If fading is acting inconsistent, please ensure that all speakers are connected to the proper polarity.

6. Verify that all SWC are functioning properly. If any of the SWC are not functioning properly you may need to reset the

interface or follow the re-calibration procedure above.

7. The LED and radio will turn off when the ignition is turned off.

Restoring Factory Settings

You can restore the interface to factory default settings by pressing and holding the programming button on the side of the module

until the status LED starts blinking red. Once the LED starts blinking red, release the button. You must release the button while

the LED is blinking red in order to perform the reset. Please note, the LED will go through two stages before it starts blinking red.

First it will blink green, then amber, then red.

This reset will restore the following settings to their factory defaults:

• SWC Mapping

• Factory Amplier Settings

• Real Time Fade will be reset to on

Testing and Verication

RadioPRO App

Use of the RadioPRO App allows

you to do the following:

• Congure User Interface Options such

as:

• Factory amplier settings (Bass,

Mid, Treble, Gain, Fader and

Balance)

• Real Time Fading

• Update Product Firmware

• Read Firmware/Hardware Versions

• Access Product User Manuals

PLEASE NOTE:

The interface must be connected to the vehicle when using the following features of the RadioPRO App:

• Factory Amplier Settings

The interface does not need to be connected to the vehicle when using the following features of the RadioPRO App:

• Firmware Updates

• Reading rmware/hardware versions

TY1A-RS

46

1234567/ 7

Bekijk gratis de handleiding van PAC TY1A-RS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van PAC (Niet gecategoriseerd)

Handleiding bekijken

PAC SRK-GM14HX

Niet gecategoriseerd - handleiding

Handleiding bekijken

PAC SRK-RAM13HX

Niet gecategoriseerd - handleiding

Andere merken in Niet gecategoriseerd