Orbit G3 handleiding

Handleiding

12345678910111213141516171819202122232425/ 25

Afdrukken

Je bekijkt pagina 13 van 25

8 – ENGLISH – Manual Text Booklet – Orbit Baby Helix Plus Upgrade Kit

Removing your old handlebars

󱪼 Start with your stroller frame open and erect. Completely unscrew both thumbscrews

Ⓑ under the

Orbit Baby Stroller G3 water bottle tray.

󱪼 Remove the old water bottle tray by pulling up firmly. Remove the stroller strap.

󱪼 Using the included Phillips screwdriver tool, remove the screw that holds the left water bottle

bushing and handlebar in place. Then remove the screw on the other side in the same manner.

Push down on the left handlebar button and pull up on the handlebar to remove it from the stroller

frame. Remove the righ

t handlebar in the same manner.

󱪼Remove the thumbscrews by taking off the small snap rings that hold them in place. Insert the tip

of the included Phillips screwdriver tool or a ballpoint pen into the small openings in the snap ring

and lever outward.

⚠

WARNING

⚠

Proper assembly is required. Check that handlebar is properly installed and fasteners are tight.

Installing your new handlebar

󱪼 Remove the two loose Phillips screws in the bottom of the handlebar assembly. Install the new

handlebar assembly by sliding the water bottle tray

Ⓚ onto the exposed aluminum handlebar

tubes. Push the water bottle tray down until it covers the square cross tube and cannot be pushed

down further.

󱪼 Using the included Phillips screwdriver tool, install the two screws through the square cross tube

and thread them into the silver fittings in the handlebar assembly. Tighten completely.

12345678910111213141516171819202122232425/ 25

Bekijk gratis de handleiding van Orbit G3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd