Handleiding
Je bekijkt pagina 13 van 36
HCE 50
13
- Check to see if it is necessary to change the flexible gas tube. If it proves necessary, obtain a new
tube and connect it as explained in Apparatus start-up.
- It is recommended that the cleaning of the apparatus be carried out with the gas tap closed, the
heater completely cold and with nonabrasive products.
- We recommend, when the heater is not in use, maintaining it in a dust free atmosphere,
protected with a cloth or plastic cover in a dry place.
BEFORE CALLING IN TECHNICAL SERVICE
The heater doesn’t turn on
Check to see if there is gas in the bottle and that the regulator is correctly coupled in the
open position.
Check to see that the tube is connected.
Check that the instructions have been followed correctly.
If this occurs after changing bottles it may be due to:
There is air in the bottle. Press the ignition button down for a longer period of time until the
pilot flame and burner ignite. Then switch to the maximum position.
The bottle may have been exposed to low exterior temperatures. Apply fairly hot wet cloths
to the upper part of the bottle to increase gasification and the normal exit of gas.
The heater goes out
If it goes out on completing the ignition instructions, repeat the operation, following the
instructions faithfully.
If it goes after 30 minutes, it is signaling that it is operating in a stuffy atmosphere. Ventilate
the room and reignite the heater.
If it goes out before 30 minutes of operation, ensure that it is not exposed to air currents or
that the bottle has not run out of gas.
Bekijk gratis de handleiding van Orbegozo HCE 50, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Orbegozo |
| Model | HCE 50 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3737 MB |
