Handleiding
Je bekijkt pagina 12 van 36
HCE 50
12
Using a brush, apply the solution on the joints between the cylinder, the regulator and the
heater.
Open carefully the valve.
If there are gas leaks, bubbles will be formed in the points corresponding to the leaks.
Close the gas valve. If there is a leak, tighten all the joints and repeat the test. Should the leak
continue, contact the supplier immediately.
IGNITION INSTRUCTIONS
Attention: before using the apparatus for the first time and after long periods of non-use, we
recommend switching on the control buttons several times alternately and without gas flow in order
to facilitate working.
The heater can be regulated to three different heat intensities: MAXIMUM, MEDIUM and MINIMUM.
The switch-on mechanism is piezo-operated.
1. Open the gas valve.
2. Press the power controller and turn it to Position 1 (Ignition/Low).
3. Keep pressed the power controller for 10 seconds.
4. Press the piezoelectric sparker several times while still holding down the power controller.
Once the flame is on, keep it pressed a few seconds and then release it.
5. Then, if you want to increase the power, press it slightly and turn it anticlockwise to the
desired level. Never use the heater at intermediate positions.
6. The ODS system will automatically turn off the appliance if the content of oxygen go down.
Before restarting the appliance, close the gas valve, ventilate the room and then repeat the
process.
TURNING OFF THE HEATER
To switch the heater off:
- Place the power controller to the position 1.
- Close the gas tap.
- ATTENTION: The gas flow will not be stopped unless you close the valve of the gas bottle.
NOTE: never move or cover the heater before it is completely cold.
MAINTENANCE
- If any anomaly is observed or spare parts are required, contact our Technical Service.
- The periodical maintenance must be carried out by exclusively by an authorized technician.
- We would recommend that you have a service carried out every two years by an authorized
technician.
- Watch the pilot light, which should be stable.
Bekijk gratis de handleiding van Orbegozo HCE 50, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Orbegozo |
| Model | HCE 50 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3737 MB |
