OmniMount DESK65 handleiding
Handleiding
Je bekijkt pagina 16 van 20
888-24-226-W-02 rev. E • 12/12
16 of 20
=
14mm
ENGLISH
APPENDIX A - Minimize Lift Tension
WARNING. Before removing mounted equipment (monitor, arm, stand CPU, etc.), from desk, or
to prepare for shipping or storing the desk it is extremely important to minimize the lift tension.
Failure to install these instructions may cause lift engine to expand rapidly and may result in
equipment damage and or personal injury.
Turn adjustment
bolts left to
minimize tension.
WARNING! DO NOT tip desk over to adjust. Only perform adjustment while desk is
upright. Failure to follow these instructions may cause the lift engine to expand rapidly
and may result in equipment damage and or personal injury.
Make sure
covers are fully
closed before
lowering the
worksurface.
NOTE: The covers on the legs will not open unless
the worksurface has been lifted to it’s full height. The
worksurface will not lower unless the covers have been
completely closed.
1. Release the hand brake (on the right leg) and move the worksurface up to
highest level.
2. Push in the cover located behind each leg to access the adjustment point.
3. To minimize tension, turn adjustment bolts left using a 14mm
socket drill. Maintain equal tension on both legs by alternating
adjustment from one leg to the other. Keep adjusting until the
wrench stops turning.
4. Once at minimum tension it is ok to remove mounted equipment.
Bekijk gratis de handleiding van OmniMount DESK65, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | OmniMount |
| Model | DESK65 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4124 MB |
