Handleiding
Je bekijkt pagina 8 van 28
08 OFOIC908BCOMUser Manual
Prior to Beginning Installation
• Ensure that the local distribution conditions and the
adjustment of the appliance are compatible;
• The adjustment conditions for this appliance are stated on
data plate;
• This appliance is not connected to a combustion products
evacuation device. It shall be installed and connected in
accordance with current installation regulations. Particular
attention shall be given to the relevant requirements
regarding ventilation.
Fitting the Anti-tilting Chain
• The cooker is supplied with an anti-tilting chain to prevent
the appliance from tilting forward and accidental damage
to the gas pipe.
• Take the expansion with hook and make an adequate hole
in the wall behind, at the same height as the chain fixing
area.
• Insert the plug into the hole and then screw in the hook
until it is firmly fixed to the wall.
• Fix the chain to the hook.
• Adjust to level of the cooker inserting the feet provided.
• For a situation where the appliance is between two
cupboards and the anti tilt chain cannot be fitted we
suggest securing by screwing through the both sides of
the cupboards into the sides of the cooker. The screws
should be fitted as follows.
• Position the oven between the cupboards in it's final
position, then mark the location of the pilot hole inside the
cupboard. Refer to the diagram for the location of the pilot
hole.
• Use 3.5m diameter drill bit to drill the pilot hole through
the cupboard and both sides of the cooker. Before drilling,
check your measurements to ensure the pilot holes are
located within the range specified in the diagram. A drilled
hole in the side of the cooker which is outside the range
specified may void the warranty.
• Inspect cupboards thoroughly before drilling to avoid
damage to electrical wires or gas lines. Fix two 12 gauge
x 40mm long self tapping screws through the pilot holes
inside both cupboards and into the side of the cooker.
• Screw length could vary depending on cupboard material
thickness and gap between oven and cupboards.
• Note: Screw length is based on cupboard thickness of
20mm, gap between cupboard and oven of 10mm.
• Note: The screws must be accessible for removal if the
cooker requires service. Cupboards must not be built over
these screws.
• Equipment type: Free standing (class 1)
• Insulation class: Class 1
• The manufacturer declines any and all responsibilities
for damages to things or injuries to persons or animals
deriving from incorrect installation or use of the
equipment.
Installation Instructions (Continued)
Bekijk gratis de handleiding van Omega OFOIC908BCOM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Omega |
| Model | OFOIC908BCOM |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2162 MB |
