Handleiding
Je bekijkt pagina 11 van 40
11User Manual
Installing Your Freestanding Cooker (Continued)
Overhead Clearances:
IMPORTANT:
• The minimum clearance between the highest point of the
cooker and any overhead surface must be at least 650 mm.
• If installing an overhead rangehood or exhaust fan, the
clearance must be at least 750 mm.
• Any combustible surface located less than 650mm above the
cooking surface must be fully protected across the entire width
of the cooktop, in accordance with local standards.
• Under no circumstances should the vertical clearance be less
than 450mm.
Rear and Side Clearances:
• IMPORTANT: Where the dimensions from the periphery of the
nearest burner to any vertical combustible surface is less than
200 mm, the surface shall be protected in accordance with the
standards to a height of not less than 150 mm above the cooking
surface for the full width or depth of the cooking surface.
•
IMPORTANT: Where the dimensions from the periphery of the
nearest burner to any horizontal combustible surface is less
than 200 mm, the horizontal surface shall be greater than 10
mm below the surface of the hob, or meet the horizontal surface
requirement above.
•
IMPORTANT: Do not install the range near flammable materials
such as curtains.
Levelling the Feet
• The height and level of the appliance can be adjusted
by rotating the feet located underneath the appliance
at each corner.
• Rotate the feet to decrease or increase the height.
Fitting the Anti-tilting Chain
• The cooker is supplied with an anti-tilting chain to prevent the
appliance from tilting forward and accidental damage to the gas
pipe.
• Take the expansion with hook and make an adequate hole in the
wall behind, at the same height as the chain fixing area.
• Insert the plug into the hole and then screw in the hook until it is
firmly fixed to the wall.
• Fix the chain to the hook.
• Adjust to level of the cooker inserting the feet provided.
• For a situation where the appliance is between two cupboards
and the anti tilt chain cannot be fitted we suggest securing by
screwing through the both sides of the cupboards into the sides
of the cooker. The screws should be fitted as follows.
• Position the oven between the cupboards in it's final position,
then mark the location of the pilot hole inside the cupboard.
Refer to the diagram for the location of the pilot hole.
• Use 3.5m diameter drill bit to drill the pilot hole through the
cupboard and both sides of the cooker. Before drilling, check
your measurements to ensure the pilot holes are located within
the range specified in the diagram. A drilled hole in the side of
the cooker which is outside the range specified may void the
warranty.
• Inspect cupboards thoroughly before drilling to avoid damage
to electrical wires or gas lines. Fix two 12 gauge x 40mm
long self tapping screws through the pilot holes inside both
cupboards and into the side of the cooker.
• Screw length could vary depending on cupboard material
thickness and gap between oven and cupboards.
Bekijk gratis de handleiding van Omega OFOGC9010X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Omega |
| Model | OFOGC9010X |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4205 MB |