Olimpia Splendid Unico Air Inverter 25 SF handleiding
Handleiding
Je bekijkt pagina 65 van 256
UNICO AIR INVERTER R32
EN - 17
ENGLISH
• To make the electrical connection and fasten the drainpipe, place a wedge between the air con-
ditioner and the wall (see g. 24).
• When you have nished, inspect carefully to make sure there are no ssures at the back of the
air conditioner (the insulating gasket must t rmly against the wall) particularly in the zone
where air enters and leaves the machine.
2.4.6 - Electric hook-up
Theapplianceisttedwithapowercordwithplug(Y-typeconnection).
If the socket is in proximity to the appliance, simply plug it in.
Before connecting the conditioner, ensure that:
• The power supply voltage and frequency values comply with those indicated
on the data plate of the appliance.
• The power supply line is tted with an efcient earth connection that is ap-
propriately sized for the maximum absorption of the conditioner (minimum
cross-section of the cable must be 1.5 mm
2
).
• The appliance is powered exclusively through a socket that is compatible with
the plug supplied.
Any replacement of the power cable must be carried out solely by authorized
technical support or by similarly qualied personnel.
On the power supply line of the appliance there must be an adequate omnipolar
disconnection device that complies with the national installation regulations.
It is, however, necessary to check that the electrical power supply is equipped
with efcient earthing and with adequate protections against overloading and/
or short circuits (a type 10 AT delayed fuse or other devices with equivalent
functions are recommended).
To replace the power cord, proceed as follows:
a. Raisetheairsuctiongrille(3)andremovethetwoscrews(1a)(g.27).
b. Aprireilap(1)erimuoverelavite(1b)(g.28).
c. Removethefrontcover(g.29).
d.
Unscrewthethreexingscrews(X2)toremovethefrontcoveroftheswitchgear(X1)(g.30)
.
e. Remove the electrical panel
(X1)(g.30).
f. Unscrewcableclippingclamp(J1)(g.31).
g.
Unscrew the cables locking screws of the terminal board
(J2)(g.31)
h. Extract the old cable and insert the new one by following the same path.
i. Lock the three poles of the cable in the
terminal board
(J2)andtightenthescrews(g.31).
l. Lockthecablewiththeclamp(J1)(g.31).
m. Close the
switchgear
.
n. Reassemble the front cover of the machine.
o. Tighten the screws (1a) and (1b).
Bekijk gratis de handleiding van Olimpia Splendid Unico Air Inverter 25 SF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Olimpia Splendid |
| Model | Unico Air Inverter 25 SF |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 32009 MB |
