Nubert nuConnect trX handleiding

Handleiding

123456789101112131415161718192021222324/ 24

Afdrukken

Je bekijkt pagina 16 van 24

nuConnect trX 16 07/2020 EN

Typical applications

Replacing a phono cable

Devices Transmitter: nuConnect trX

(examples) Receiver: nuConnect trX

You can use two nuConnect trX’s to replace a stereo phono cable. This is rec-

ommended as an alternative to long cable-runs or in situations where room

constraints make it impractical or impossible to use a cable.

• Configure one nuConnect trX as the transmitter (line in,

green LED) and

another as the receiver (line out, yellow LED).

Note:

Compared to a wired connection, a wireless connection using the trX adds 20 ms

of latency (delay) to the signal.

Creating a fully independent zone using nuPro X-series speakers

Devices Transmitter: nuPro X-8000

(examples) Receiver: nuConnect trX w. nuPro X-3000 in Zone 2

When used in the wls slave mode, a nuPro X speaker is controlled by a mas-

ter-speaker and its level cannot be controlled independently. This beahviour

eases daily operation in classic two-speaker setups but can be problematic if you

wish to create a second, independent zone. To make your zone 2 independent,

you can use a trX.

• Connect the trX to the Digital Port-input (USB) of the Zone 2 Master speaker

(here the X-3000). Configure the trX as a receiver (Digital Port Out, blue

LED) and pair it with the Master speaker in your main zone (here the X-8000).

• The X-3000 now functions independently of the main zone. Music from the

main zone can be listened to by selecting the port input.

Note:

The main-zone nuPro X-8000 stereo-pair must be connected wirelessly.

123456789101112131415161718192021222324/ 24

Bekijk gratis de handleiding van Nubert nuConnect trX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd