Nord Stage 4 handleiding
Handleiding
Je bekijkt pagina 52 van 76
52 | NORD STAGE 4 USER MANUAL OS V1.4X
ROTARY SPEAKER
The Rotary Speaker effect accurately reproduces the sound of the rotating
horn and bass rotor, as well as the characteristics of the built-in amplifier of
the original rotary construction.
• The most common use case for the Rotary Speaker would be to combine
it with an Organ sound, which is achieved by pressing ORGAN in the
Rotary Speaker section.
• To use the Rotary Speaker with sounds from the Piano and/or Synth
sections, activate TO ROTARY in the Amp/EQ effects unit for the Layer that
should be sent to the Rotary Speaker.
• Switch between fast and slow rotor speeds by pressing the SLOW/STOP-
FAST button.
• To stop the rotors, press the STOP MODE button and set the speed to
SLOW/STOP.
• To have the speaker sound exactly the same every time Stop Mode is
active, select ANGLE by pressing Shift+Stop Mode and choose one of the
positions from the list. This way the rotor and horn will always stop at the
same positions. With the default Free setting, the Stop Mode sound will
vary depending on the angles at which the horn and rotor have stopped.
• The rotor and horn acceleration rates, i.e. the time it takes to go from slow to fast and vice versa,
can be adjusted in the Sound menu, read more on page 57.
• The Rotary speed can be continuously controlled with a Morph source, making it possible to set
the rotary at speeds other than just fast, slow or stopped. Set this up by holding down any of the
Morph Assign buttons and pressing the Rotary speed button. An active morph is indicated by the
MORPH LED being lit.
• Pressing CLOSE MIC (Shift+Organ) switches to a version of the Rotary Speaker which is modelled
with the microphones placed closer to the horn speaker. This produces a more pronounced
stereo effect and an increased sense of motion. This setting is stored per program.
The DRIVE knob controls the amount of overdrive. This simulates the pre-amplifier overdrive of the
original rotary speakers.
A sustain pedal or a foot switch that is connected to the Rotor pedal input can control the rotor
speed. On the Nord Stage 4 Compact model, the optional Nord Half Moon Switch can be used for
switching Rotary speed in an even more traditional fashion. Read more about rotor control on page
59.
i The Rotary Drive parameter is dependent on the processed instrument’s Level setting. If the
instrument being processed by the Rotary is set to a very low level, the amount of available
drive will be significantly reduced. Again, this is very much like how it works with the “real
articles” - when you increase the organ level, e.g. by using a swell pedal, the amount of
distortion from the Rotary effect increases.
ROTARY SPEAKER AND REVERB
On any Layer that is routed to the Rotary Speaker the Reverb, like all other effects, is applied before
the Rotary Speaker.
ROTARY MENU SETTINGS
There are several parameters in the Sound Menu that allow for detailed adjustments of the
behaviour and sound of the Rotary Speaker. Read more about on this on page 57.
Bekijk gratis de handleiding van Nord Stage 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Stage 4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10906 MB |
