Nord Stage 4 handleiding
Handleiding
Je bekijkt pagina 27 van 76
6. SYNTH | 27
6
SYNTH SECTION
ABOUT THE SYNTH SECTION
Each of the three Layers in the Nord Stage 4 Synth Section provides a
wide array of both classic analog waveforms and rich digital waves, as
well as FM algorithms and samples.
Using the Unison modes and/or the Multi or Super analog waveforms,
sounds utilizing a large number of oscillators can be used – without any
loss of polyphony.
The dedicated Synth display and its three dials are used both for
browsing Waveforms and Samples, as well as for making Envelope,
Filter or other Synth settings. Functions that utilize the display for its
settings are indicated with a red frame around the corresponding button.
With the Synth Section set to Extern mode, the display and its dials are
used for controlling Program and Parameter changes on external gear.
Read more about the Extern mode on page 45.
ON/OFF AND LEVEL
The Synth section is turned On or Off by pressing its ON button. The
morphable faders control the sound output level of each Synth Layer.
Press the On button for roughly half a second to perform a SOLO
operation, which activates only the Synth, turning off the Organ and
Piano sections.
LAYER BUTTONS AND FX FOCUS
There are three independent Synth Layers; A, B and C. Turning a
Layer on is done by pressing all Layer buttons that are already active
simultaneosly with the one that should be turned On. Turning a Layer Off
is done by holding its button down for a short period of time.
To toggle from one Layer to the other, press a non-active Layer button.
With multiple Layers active, the focused Layer is indicated by a blinking
LED above the Layer button.
Pressing a Layer button also focuses that Layer’s effects for editing. The
FX FOCUS LED at the top of the Synth Section indicates that its effects
are focused for editing.
OCTAVE SHIFT AND KB ZONE
Use OCTAVE SHIFT 3/4 to transpose the selected Layer up or down
by octaves (+/- 12 semitones). When assigned to the entire keyboard it
can be transposed one octave up or down. When assigned to a smaller
zone the available transpose values will vary, but always provide access
to the entire range of the Synth.
Press KB ZONE 3/4 (Shift+Octave Shift Down/Up) to assign a Layer
to any of the active keyboard zones. The green KB ZONE LEDs indicate
which of the zones the Layer is assigned to. Read more about Split
set-ups and keyboard zones on page 38.
Multi Saw 8ve
WAVE
2(6)
MULTI
4.5
ANALOG
DETUNE:
TYPE CAT
OSC WAVEFORM
Bekijk gratis de handleiding van Nord Stage 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Stage 4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10906 MB |
