Nord Piano 6 handleiding
Handleiding
Je bekijkt pagina 24 van 40
24 | NORD PIANO 6 USER MANUAL OS V1.1X
for shaping the delay sound, especially when large feedback amounts
are used. Each consecutive Delay repeat is fed through the filter,
resulting in a progressively more filtered sound.
With the LP setting, all delay repeats are passed through a Low Pass
filter which reduces high frequency content in the delay feedback signal.
The HP setting provides a High Pass filter, removing low frequency
content. This can be useful for making long delay tails sound less
muddy.
The BP setting adds a Band Pass filter to the delay signal. This will
reduce both high and low frequencies, making for a thin and narrow
sound.
FLAM
The FLAM effect produces a stereo delay with offset left and right
channels. This is useful at short delay times for room effects, or for more
complex sounds at longer delay times.
Combined with the Ping Pong mode, the Flam effect instead produces
multiple repeats per left and right tap.
TEMPO TAP
Use TAP to set a delay time matching the tempo of a song. The tempo
is displayed both as a BPM (Beats Per Minute) value as well as in
milliseconds. Simply tap the Tempo button at the tempo you wish the
Delay to sync to a number of times, and the Delay time will be adjusted
automatically.
l A minimum of two taps is required for defining a tempo, but
the button can be tapped as many times as needed for further
fine-tuning of the delay time.
EQUALIZER
The three band EQUALIZER features controls for bass, a sweepable
middle band and treble.
The equalizer can be set to GLOBAL (Shift+On) mode, which applies the
same settings to all Piano and Sample Synth Layers.
The BASS frequency is set to 100 Hz, the TREBLE frequency is 4 kHz
and the sweepable middle band can be set between 200 Hz to 8 kHz,
using its FREQ knob.
The boost/cut range is +/- 15 dB for all bands.
AMP
The AMP unit includes sophisticated amplifier and speaker cabinet
simulations and versatile tube-like distortion. The amount of overdrive is
controlled with the DRIVE knob. The LED indicates when the overdrive is
active.
TUBE OVERDRIVE
With no Amp Model selected the Amp unit provides a tube style
overdrive effect which can be used for anything from subtle saturation to
screaming distortion.
AMP MODELS
There are three different amplifier/speaker simulations, each with its
distinct character:
SMALL: A simulation of the built-in tube amp and speakers of a
reed-based electric piano.
JC: A simulation of a classic solid-state amplifier and speaker cabinet.
TWIN: A simulation of a classic twin speaker tube amplifier and cabinet.
ALT TONE
The ALT TONE setting (Shift+selector button) alters the frequency
response and character of each amplifier model.
For the Twin and JC models, the mid range changes in character and
the treble is reduced. For the Small amp model, Alt Tone provides an
even smaller amp and speaker simulation which is distinctly “radio like”
in character.
COMPRESSOR
The COMP (Compressor) effect reduces the dynamic range of the
sound, making low level signals louder and high level signals more quiet.
This produces a tight, punchy sound and makes the overall level easier
to control in a live mix situation.
The ACTIVE LED indicates when the Compressor threshold is surpassed
and compression is applied to the source sound.
The Compressor effect can be set to GLOBAL (Shift+On) mode, which
applies the same settings to all Piano and Sample Synth Layers.
Bekijk gratis de handleiding van Nord Piano 6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Piano 6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5117 MB |
