Nord Organ 3 handleiding
Handleiding
Je bekijkt pagina 14 van 40
14 | NORD ORGAN 3 USER MANUAL OS V1.0X
ABOUT THE ORGAN MODELS
The Nord Organ 3 features five organ models,
all digitally modeled; a tonewheel B3 organ, two
transistor organs (VX and FARF), the SOFT B3 and
the PIPE model.
i The Rotary Speaker is covered in a separate chapter, see page
18.
SELECTING AN ORGAN MODEL
Use the ORGAN MODEL selector button to select an Organ Model for
use. The Bass Model is selected independently, and can be set either to
a model corresponding to the Organ Model being used, or to any other
available model. Read more about Bass Model options on page 16.
B3 INIT
Use the B3 INIT command (Shift+Organ Model) for quickly setting up a
program with default settings using the B3 Organ and Bass Model, the
Rotary Speaker at its default settings, and no other effects active.
THE B3 MODEL
The B3 model is based on the classic electro-mechanical tonewheel
organ. This simulation utilizes innovative and advanced methods to
capture every nuance of the original sound. Here are some examples:
• An extremely accurate capture of the original chorus and vibrato
scanner.
• Modeling of the individual contact bounces for each harmonic.
• Modeling of the unique frequency characteristics of the built-in
pre-amplifier, which forms the “body” of the sound.
• Simulation of the energy robbing on the tone wheels that results in the
typical “compressed” sound.
• Authentic tuning of the tonewheels according to the original design.
• Extremely fast keyboard response.
• Full polyphony.
B3 DRAWBARS
The harmonic intervals for the tonewheel organ are printed on the panel
below the drawbars. Each drawbar represents a partial with a fixed
harmonic interval in relationship with the played note.The illustration
below shows the pitch interval among the nine drawbars when the key
of C3 is played. Note that the 5 ⅓′ drawbar actually is a 5th above the
fundamental harmonic (8′) but in most situations is perceived as
sounding below it.
l Do not forget to try out the three tonewheel modes that are
available in the Sound menu. These will change the sound of
the B3 model from a clean, factory new unit to a battered, old
workhorse.
B3 CHORUS/VIBRATO
The original vibrato and chorus scanner in a
tonewheel organ consists of a tapped delay
line in combination with a rotating scanner. For
the Vibrato effect, phase shift is applied to the
signal. With Chorus, the phase modulated signal
is added with the original signal.
Three different types of choruses (C1 - C3) and
three types of vibratos (V1 - V3) are available.
Select one of these types by pressing the
selector button. The effect can be activated/deactivated for both
manuals individually by using the UPPER and LOWER On/Off buttons.
The DEEP CHOR (Deep Chorus, Shift+Vibrato/Chorus) setting increases
the modulation amount of the Chorus effect. The non-Deep and Deep
Chorus settings correspond to early and late eras of the original design.
C3
16 5
⅓ ⅔ ⅗
8 4 2 1
⅓
1 1
2
Bekijk gratis de handleiding van Nord Organ 3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Organ 3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4761 MB |
