Nord Modular G2 handleiding
Handleiding
Je bekijkt pagina 155 van 291
NORD MODULAR G2 V1.4x 13. Module reference:
Page 155
13. MODULE REFERENCE
The Nord Modular G2 modules are grouped in 16 module groups, which you access by clicking on the
module group buttons in the toolbar. The modules are visually identified with illustrations. When you
place the cursor over an illustration, a module preview and a brief description appears.
When you add a new module to a patch, the Nord Modular G2 mutes the outputs for a short moment,
as the Editor program will have to optimize the
DSP
engine data and occasionally reallocate the voices in
the active Slots to other
DSP
engine resources. Theoretically, you could use over 200 modules in each
patch, about 100 in the Voice Area and 100 in the FX Area, but you will probably run out of
DSP
engine
resources before reaching the module limit.
DSP
engine resources are shown in the two Patch Load Cycles
and Memory displays in the toolbar. It is possible to use several modules of the same type in both Areas
of a Patch, except for the ‘FX Input’ module which can only be used in the FX Area.
In this Module Reference chapter the description of each module group is preceded by explaining
parameters that are common for all modules in the specific group. If you don’t find descriptions of
certain parameters together with the individual modules, check the module group introduction parts.
Bekijk gratis de handleiding van Nord Modular G2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Modular G2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 60689 MB |
