Nord Lead 2 handleiding
Handleiding
Je bekijkt pagina 44 van 114
Page 44 Panel Reference
BP: To select this type of filter, press the Filter Type button until both the HP and LP 24 buttons light up.
BP stands for band pass. In this mode the filter let’s frequencies in the “mid-range” band pass through,
while lower and higher frequencies are cut out. Each “slope” in this filter has a 12dB (2-pole) roll-off.
Notch+LP: To select this type of filter, press the Filter Type button until both the LP 12 and LP 24 buttons
light up.
A notch (or band reject) filter can be seen as the opposite of a band pass filter. It cuts off frequencies in
a “mid-range” band, letting the frequencies below and above through. However, a plain notch filter is
not very musically useful, since it often lets too many frequencies through, resulting in a very sharp, harsh
sound. Therefore, the notch filter in Nord Lead 2 is combined with a 12dB Lowpass filter, resulting in a
filter curve that looks like this:
The audible result of this filter combination is a sound with plenty of body, some of the upper mid-range
“bite” removed but a certain amount of high frequencies still present. This type of sound could be very
useful for soft, yet clear pads, etc.
The special characteristics of the Notch+LP filter will be most obvious with low Resonance settings.
Amplitude
Frequency
Fc (Cutoff Frequency)
Amplitude
Frequency
Fc (Cutoff Frequency)
Bekijk gratis de handleiding van Nord Lead 2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Lead 2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11965 MB |
