NEO Tools 90-094 Handleiding (88 Pagina's)

Handleiding

3. Insert the metal screws into the plastic rails.

4. Lift the heater and aim the round holes on the brackets at back of the heater to the screws on the wall and slide the heater 10mm to the

right

5. Make sure the distance between the bottom of the heater and the floor is no less than 10cm when the heater is installed

USING INSTRUCTIONS

Control panel/Remote control

1. Setting Button

2. Up Button

3. Down Button

4. Power Button

5. Heating Element Working Indicator

6. Low Heating Indicator

7. High heating Indicator

8. Timer Indicator

9. Temperature Indicator

10. LED Number Display

11. ECO function

12. Low/High Heating Selection

13. WiFi indicator (If connected OK, wifi indicator lights on; if failed)

Starting

− Take out the heater from the carton carefully. Please save the carton for off-season storage.

− Make sure the power switch is in the OFF position before plugging it in.

− Ensure the heater is fulyy assembled according to the Mounting Guide.

− It’s better not to use the same electric outlet with other high wattage electrical appliances in order to avoid overloading you circuit.

Turn ON

Plug in and turn on power switch, heater is in stand-by with buttons 1/2/3/4 on. Press button 4, heater turns on, display shows current area

temperature.

Plug in the unit and turn on its power switch, it is in standby mode and shows current time, with button light 1/2/3/4. on. But then button light 1/2/3

will disappear after 10s.

Temp. Setting

Press button 1, temp. indicator flashes and its setting is activated. By pressing buttons 2 and 3, we select desired temp. and save it. Heater is

heating, display shows current temperature and button 5 lights on.

Bekijk gratis de handleiding van NEO Tools 90-094, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.