MSW -PASO D220 handleiding
Handleiding
Je bekijkt pagina 38 van 399
EN
7. Analysis and Elimination of Obstacles
Failure phenomenon
Causal Analysis
Troubleshooting
Not work
1. Power is not connected.
2. Fuse blow out.
3.
The contact point of the
power switch is loose.
1. Check the power socket.
2. Change the fuse.
3.
Check, tighten, repair or
replace.
The paper tape is not evenly
coated with water
1. Long-term use causes
the glue on the tape to
accumulate on the brush.
2.
Damaged and deformed
brush surface.
1. Wash the brush with mild soap
and water.
2. Replace the brush.
Paper tape coated with too
little water
1. Less water in the tank.
2.
The pressure of the
balance block above the
brush is not enough.
1. Adjust the height of the water
tank to increase the water output.
2. Adjust the
position of the
balance block to increase the
pressure on the surface of the
balance block and the brush.
The cutter can't cut the tape
1. Glue, dust and other
foreign matters are stuck on
the blade edge.
1.
Use a scraper to remove
foreign matters from the blade.
The paper tape jammed
1. The tank position is not
installed in place.
2. The balance block is too
heavy.
1. Re-install the water tank so that
it is in place and cannot be moved.
2.
Replace with a thin balance
block.
Bekijk gratis de handleiding van MSW -PASO D220, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -PASO D220 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 45247 MB |
