MSW -PASO D220 handleiding
Handleiding
Je bekijkt pagina 36 van 399
EN
7.5 The different grades(weights) of sealing tape(listed in order of increasing strength)
Paper tape
Economy grade reinforced tape
Light weight reinforced tape
Medium weight reinforced tape
Heavy weight reinforced tape
Extra heavy weight reinforced tape
Boxmakers tape
7.6 Selecting tape
Use the lightest and thinnest tapes for cartons:
Of low value
Shipped a short distance
Stacked on a pallet and wrapped in shrink wrap
Use the heavier and thicker tapes for cartons that:
Are heavy
Have great value
Are shipped long distances
Are shipped individually and are not shrink wrapped
7.7 Proper tape moistening
Dispense a piece of tape and examine the adhesive surface. The tape should:
Be evenly wet
Have no dry spots
Have no spots where water is running off the surface
Rub the wet adhesive with your finger.
The adhesive should have an "oily" feel and consistency.
You should be able to move the adhesive underneath your finger.
When you rub two wet adhesive surfaces of the tape together against each other, you should
see “strings" of adhesive stretching between the two surfaces as you pull them apart, looking
much like taffy as it is pulled.
If the tape is too wet or watery, it:
Will not set fast enough
May slip slightly over the surface of the carton, causing a "loose" seal
If the tape is not wet enough, it:
May be tacky or sticky like pressure sensitive tape, but not "oily" like properly moistened
tape.
Is too dry to properly activate the adhesive which will prevent a permanent bond from
forming (because the adhesive cannot penetrate the corrugate fibers).
May too easily pull off the carton during handing and transportation.
7.8 Adjusting the amount of water applied to the tape
Adjust the height of the water bottle
Higher to apply more water
Lower to apply less water
Never use any dispenser for water-activated tape without a water bottle
Do not add water to the water bottle "whenever it looks low". This will always
Cause overwetting when the tank is first filled
Cause underwetting when it needs to be refilled
7.9 Choosing the correct tape length
In most situations, the correct length of tape is the total length of the seam to be sealed plus
a two to three inches (5cm-8cm) overlap on each side.
On extremely long cartons, such as those used for furniture or mattresses, an overlap of
Bekijk gratis de handleiding van MSW -PASO D220, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -PASO D220 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 45247 MB |
