MSW -MH-680 handleiding
Handleiding
Je bekijkt pagina 10 van 129
EN
Installation
CAUTION! The machinery must be installed and commissioned by qualified personnel. All relevant
safety regulations must be strictly adhered to! Use the disassemble drawing as your guide to assemble.
1. Attach the bottle Jack to the jack mounting plate.
2. Pump the jack into the proper position and secure the piston with the lifting frame.
3. Attach the safety bar and safety bar handle to the lifting frame.
4. Attach the foot pedal and handle.
5. Tighten all bolts and nuts.
Operation
Preparation
1. Purge air away from the hydraulic system.
Manual operating system: Let the lift in the lowest position, fully press the release foot pedal, then
quickly press the lifting foot pedal 10-20 times to eliminate any air in the hydraulic system.
2. Carefully and slowly pinch the oil fill plug to release the trapped air.
3. Position the lift in a suitable area, checking that the surface on which the lift will stand is solid and flat.
To raise the vehicle
1. To avoid item from slipping during the raising operation, ONLY lift on points of the vehicle specified by the
vehicle manufacturer in the vehicle’s operator’s manual.
2. Place the lift under the vehicle so that the Lift Saddle is positioned under the vehicle’s lift point.
3. Pump the lifting foot pedal until the lift saddle comes in contact with the vehicle to be lifted, always check
to be sure that the saddle and the vehicle are positioned correctly BEFORE raising the jack.
4. Apply tie-down straps (sold separately) BEFORE lifting the motorcycle. Thoroughly tighten the two tie-
down straps.
5. Pump lifting foot pedal to raise vehicle until tip of safety bar moves past desired lock position ridge. The
tip of the safety bar will sink into position just behind the ridge. Depress the release pedal slightly so that
the tip moves snugly against the ridge.
6. Once the vehicle has been raised to the desired working height, then locking safety support.
To lower the vehicle
1. Raise the lift slightly and pull back on the safety bar handle to release the safety bar.
2. Pull the safety bar handle to release the safety lock.
3. Press the release pedal very gently to lower the saddle and vehicle.
4. Remove the tie-down, then vehicle.
Bekijk gratis de handleiding van MSW -MH-680, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -MH-680 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 26682 MB |
