MSW -ISU-M190W handleiding
Handleiding
Je bekijkt pagina 7 van 66
EN
Operation
Set the temperature control knob to a midrange setting, place the blade against the edge of the
foam, and depress the trigger. Optimum cutting should be virtually smoke-free.
Note: For best results, practice on scrap pieces of foam.
When cutting foam, maintain consistent temperature and speed. If smoke develops during the cut,
you are cutting too slowly or the blade is too hot, which could result in an oversized, uneven cut. To
remedy this, lower the temperature and intermittently release the trigger during your cut. As cutting
resistance increases, depress the trigger again. The hot knife will reach the set temperature within
seconds. You can accomplish your cut with minimal smoke using this process. Cutting in this manner
will also prolong the life of the knife.
Releasing the trigger approximately one or two inches prior to completing the cut will help keep the
blade clean and free from buildup.
The selected cutting blade should not extend more than 3/4" past the thickness of your foam board.
The foam cools the blade as it cuts. The exposed portion can overheat and cause your blade to warp.
Guidelines and cautions:
1. Consult the foam manufacturer's MSDS sheet for flash points and toxicity of the material you
will be cutting.
2. Always operate the product in a well-ventilated space.
Bekijk gratis de handleiding van MSW -ISU-M190W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -ISU-M190W |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8803 MB |
