MSW -ISU-GIL ALU1 S1 handleiding
Handleiding
Je bekijkt pagina 12 van 120
EN
OPERATION (Hot cutting knife)
a) Set the temperature dial to the desired temperature - temperature control dial has 16-click settings that
correspond to the graduated ridges on the surface. The smaller the ridge the lower the heating power setting.
b) Position the blade on the workpiece.
c) Turn on the heating trigger and warm up the tool a few seconds before starting to cut (making a test cut on
waste pieces is recommended).
d) Maintain consistency of temperature and speed. Too much mist/vapor may be caused by low speed or
excessive temperature. This will result in irregular/uneven cut paths. You can solve this problem by lowering the
blade temperature or loosening the trigger.
e) Let go of the heating trigger before the last 3-5 cm of the cut is completed.
f) Proper temperature and cutting speed not only improve productivity, but also extend tool life.
g) Cutting time should not exceed 15 seconds.
CUTTING VARIANTS
STRAIGHT CUT
Bow – adjust angle right and left to 0 degree. Mark
the required dimensions on the polystyrene sheet.
Lift bow in order to draw the material to be cut
underneath the cutting wire. Place the material on
the placement angle and pull it forward up to the
required measure. Press pushbutton and keep it
pressed (cutting wire heats up) Pull bow in direction
of the material –
material will be cut. Release
pushbutton.
DIAGONAL CUT
Bow – adjust angle right and left to 0 degree. Mark
the required step (height and length) on the
polystyrene sheet. Lift bow in order to draw the
material to be cut underneath the cutting wire up to
the marked length. Press pushbutton and keep it
pressed (cutting wire heats up). Pull bow in direction
of the material –
step depth will be cut. When
reaching the step depth pull the material to the left
until the step is completely cut. Release
pushbutton.
Bekijk gratis de handleiding van MSW -ISU-GIL ALU1 S1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -ISU-GIL ALU1 S1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 37843 MB |
