MSW -DEH580B handleiding
Handleiding
Je bekijkt pagina 8 van 31
14
Rev. 10.11.2021
15
Rev. 10.11.2021
EN
EN
3.3.5 FULL RESERVOIR INDICATOR LIGHT
In the event of a full water reservoir, the device will
automatically stop working and activate a continuous
alarm informing about its fullness, additionally signaling
this fact with an icon on the control panel (see the
description of the display). Drain the water from the tank.
To do this, rst turn the device o with the POWER button
(1), then open the front panel of the device and, grasping
the handle on the reservoir, slide it horizontally away from
the device. After emptying it, reinstall it in the device in the
reverse order of the removal. Press the POWER button (1)
to restart the device.
The icon of a full tank may also activate in case of its
incorrect assembly – then its mounting should be improved
and the device will restart automatically.
There is an alternative method of emptying the device of
accumulated water: turn the device on with the POWER
button (1), then open the front panel and remove the
water tank. Put the hose of appropriate size (not included)
through the drain hole at the base of the device and attach
one of its ends to the special connection inside the tank
compartment, taking care that the drain hose is not twisted
or bent anywhere. Put the water tank back into the device
and close the front panel.
3.3.6 INTERNAL DRYING FUNCTION
When the device is turned o, press the IN-DRY button
(6) on the control panel. This function dries the inside of
the device from the accumulated moisture, thus extending
its life.
3.3.7 DEFROST FUNCTION
At low indoor temperatures, frost may build up on the
evaporator, reducing the air ow during drying. In this
case, the device will automatically start the defrost function
– it will stop the compressor, and the fan will continue to
work. Do not turn the device o during this time! Activation
of this function will be signaled by the blinking of the
appropriate indicator lamp on the display (see display
description). After defrosting, the device will automatically
go into the dehumidifying mode.
3.4. CLEANING AND MAINTENANCE
a) Unplug the mains plug and allow the device to cool
completely before each cleaning, adjustment or
replacement of accessories, or if the device is not
being used.
• Wait for the rotating elements to stop.
b) Use only non-corrosive cleaners to clean the surface.
c) Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
d) Do not spray the device with a water jet or submerge
it in water.
e) Do not allow water to get inside the device through
vents in the housing of the device.
f) Clean the vents with a brush and compressed air.
g) The device must be regularly inspected to check its
technical eciency and spot any damage.
h) Use a soft cloth for cleaning.
i) Do not use sharp and/or metal objects for cleaning
(e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
j) Do not clean the device with an acidic substance,
agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage
the device.
k) Inspection and replenishment of the refrigerant may
only be performed by a specially qualied person
and with the use of specialized equipment!
p) With regular use, clean the air lter every 6 weeks.
Turn the device o. The air lter is located at the front of
the device – after removing or opening the front panel,
remove the mesh lter. In the case of light dirt, remove the
accumulated dirt on the mesh surface with a clean cloth.
In the case of heavy contamination, also inside the lter
screen, rinse the lter under a tap with running water and
dry it completely before reinstalling it in the device.
3.3.8 TROUBLESHOOTING
PROBLEM
ACTIVITY/
POSSIBLE
REASON
SOLUTION
The device doesn’t
work
Is it properly
connected
to the power
supply?
Check the con-
nection.
Check if the
full tank in-
dicator light
is o on the
display.
Drain the tank
and reinstall it
in the device or
check if it is cor-
rectly mounted.
Check the
ambient tem-
perature.
The ambient
working temper-
ature should be
in the range of
5–35oC.
Steam is slightly
condensing
Check the
air lter for
debris.
Clean the air lter
if necessary (see
"Cleaning and
maintenance").
Check if the
air duct is not
blocked.
Remove any for-
eign matter from
the air duct.
Check if the
indoor tem-
perature is
below 20oC.
Normal behavior
– low humidity in
a low tempera-
ture environment.
The set tar-
get humidity
is higher than
the actual
indoor hu-
midity.
Set the target
humidity level
lower than it is
indoor.
Water leak
Overow
when moving
the device.
Drain the water
tank before
transport.
Is the drain
hose kinked
or bent?
Correct the
arrangement of
the drain hose.
The device is
excessively noisy
Is the device
stable?
Place the device
on an even and
stable surface.
Check for
loose parts in
the device?
Mount or secure
these elements or
contact the man-
ufacturer's service
department.
The noise
sounds like
owing
water.
The sound is
made by the
circulating
refrigerant and it
is normal.
An error
code is
dis-
played
„E1”
Tempera-
ture sensor
defective.
Check a connec-
tion or replace
the sensor.
„E2”
Moisture
sensor dirty
or broken.
Clean or replace
the sensor.
„E3”
Indoor
tempera-
ture sensor
defective.
Check a connec-
tion or replace
the sensor.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems.
Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product,
instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with
their markings. By choosing to recycle you are making
a signicant contribution to the protection of our
environment.
Contact local authorities for information on your local
recycling facility.
CAUTION! Do not use the device without the air lter
– it may pollute the evaporator! Do not touch the
evaporator surface with bare hands – the risk of injury!
Bekijk gratis de handleiding van MSW -DEH580B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -DEH580B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7397 MB |
