Moulinex Optimo GM4110 handleiding
Handleiding
Je bekijkt pagina 25 van 29
23
GB
1. Steam control dial
2. Iron temperature adjustment button
3. Temperature setting mark
4. Thermostat light
5. Boiler cap
6. Iron rest
7. Boiler (inside the base-unit)
8. Steam cord
9. Steam cord storage space
10. Electric cord tidy
11. Power cord
12. Illuminated on/off switch
13. Steam flow adjustment dial*
14. Steam ready indicator light*
DESCRIPTION
WHAT WATER TO USE ?
• Your iron has been designed to operate
using untreated tap water. However, it is
necessary to operate the Self-Clean
function regularly in order to eliminate hard
water deposits from the steam chamber.
• Types of water not to use: Heat
concentrates the elements contained in
water during evaporation. The types of
water listed below may contain organic
waster, mineral or chemical elements that
can cause spitting, brown staining or
premature wear of the appliance: water
from clothes dryers, scented or softened
water, water from refrigerators, batteries, air
conditioners, rain water, boiled, filtered or
bottled water. These types of water should
NOT be used in your MOULINEX steam
generator. Also only use distilled or
demineralised water as advised left.
• Ironing Boards: Due to the powerful steam
output, a mesh type iorning board must be
used to allow any excess steam to escapte
and to avoid steam venting sideways.
Be careful : if your water is very hard
(check with your local water authority) it is
possible to mix tap water with store-bought
distilled or demineralised water in the
following proportions : 50% untreated tap
water, 50% distilled or demineralised water.
FILLING THE BOILER
• Place your steam generator on a flat,
stable, heat-resistant surface.
• Check that your appliance is unplugged
and cold.
• Unscrew the boiler cap.
• Using a water jug, fill with maximum 1 litre of
water. Fill the boiler, taking care that the
water does not spill over - Fig.1.
Be careful : if this occurs, remove the
excess water.
• Replace the boiler cap, screwing on firmly,
but not over tight.
STARTING THE GENERATOR
Be careful : The first time the appliance is
used, there may be some fumes and smell
but this is not harmful. They will not affect
use and will disappear rapidly.
• Unwind the electric cord completely and
take the steam cord out of its housing.
• Plug your generator into an earthed socket.
• Press the on/off luminous switch. It comes on
and the boiler heats up.
• After approximately 8 minutes or when the
steam ready indicator light* comes on, the
steam is ready.
• During ironing the iron’s thermostat light and
the steam indicator* will go on and off
according to the temperature control.
PREPARATION
STEAM IRONING
• Set the iron temperature adjustment dial
and the steam flow adjustment dial* to the
type of fabric to be ironed (see table
below).
• The thermostat light comes on.
Be careful : the generator and the iron are
ready to iron when the steam ready
indicator light* is lit and the iron thermostat
dial light has gone out.
• To obtain steam, press on the steam control
button on the iron handle - Fig.2.
• The steam will stop when you release the
button.
Be careful : always replace the iron, flat on
the iron rest and never on it’s heel.
USE
* depending on model
Pressing Optimo 00010789ok 13/07/06 15:28 Page 23
Bekijk gratis de handleiding van Moulinex Optimo GM4110, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Moulinex |
| Model | Optimo GM4110 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3181 MB |
