Motorola CLP446 handleiding
Handleiding
Je bekijkt pagina 34 van 700
RADIO CLONING
22
English
2. Plug one side of the cloning cable
microconnector to one Single Unit Charger.
Plug the other end to the second Single Unit
Charger.
Note: During the cloning process no power is
being applied to the Single Unit Charger.
The batteries cannot be charged. A data
communication is being established
between the two radios.
3. Turn ON the “Target Radio” and place it into
one of the Single Unit Chargers.
4. On the “Source Radio”, power the radio
following the sequence below: • Press and
hold the Push-to-Talk (PTT) and the “-“
Button simultaneously while turning the radio
ON until you hear the Cloning Tone and
Double Blinking Yellow on the Smart
Status Glow.
5. Place the “Source Radio” in its Single Unit
Charger with an Audio accessory, then press
and release Menu Button to start the cloning
process.
6. After cloning is completed, the “Source
Radio” sounds either a “pass” tone (cloning
was successful) or a “fail” tone (cloning
process has failed). The pass tone sounds
like a good key “chirp” whereas the “fail” tone
sounds similar to a “bonk” tone. (A tone is
heard in no more than 5 seconds).
7. Once you have completed the cloning
process, you should turn the radios “OFF”
and “ON” to bring them to normal user mode
(exit “clone” mode).
68012001063_CLP_en.book Page 22 Wednesday, July 19, 2017 4:44 PM
Bekijk gratis de handleiding van Motorola CLP446, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Motorola |
| Model | CLP446 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 49885 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 67.5 g |
| Ondersteund aantal accu's/batterijen | 1 |
| Maximumbereik | - m |
| Frequentie | 12500 MHz |
