Mitsubishi MR-HS421EX handleiding
Handleiding
Je bekijkt pagina 7 van 24
7
Before use Operation Cleaning Troubleshooting
Adjustment and Anchoring
● Adjust the tilt with the adjustable supports.
Anchor the refrigerator to
a strong and level floor by
adjusting the adjustable supports.
Otherwise, the refrigerator may
move and cause injury.
Bottom front of refrigerator
A few days after installation, the floor may sink due to the refrigerator's
weight. Readjust the tilt with the adjustable supports.
*1 Normally, use a board with a thickness of 2 to 3 mm.
● After adjustment, attach the adjustable support cover.
(The adjustable support cover is stored inside the refrigerator
compartment at shipment)
Adjustable
Support Cover
Adjustable
Support Cover
Fully insert the adjustable support
cover horizontally until it touches
the rear side.
Adjustable
Support
Caster
Start using
●
It takes time to cool down.
•Put in warm food items or ice
cream after the refrigerator has
been adequately cooled down.
•Keep opening and closing of
the door to a minimum,
and open in a short time.
•In the summer, it will take
approx. 24 hours to make
the first batch of ice.
● It may smell of plastic.
•
The smell will gradually disappear.
Please ensure room is adequately
ventilated to remove odors.
●
When the refrigerator is in cooling
mode the following may occur
(also occurs during summer).
•
The side will be hot allowing the
outside of the refrigerator to cool.
•Operating noise will be loud
due to the compressor being
in high-speed operation.
Because flammable
refrigerant is used,
this may result in fire
or an explosion.
Do not damage or
drive screws into
the refrigerator's
refrigerant circuit
(pipes).
Prohibited
Use in hot spring and
geothermal areas
Corrosion control treatment may be
required for the refrigerant circuit
(pipes) due to generation of corrosive
gases. Contact the retail store where
you purchased the refrigerator.
(To prevent vibration, noise,
movement, and doors left ajar)
Follow the
instructions
Turn the adjustable supports to the floor and
anchor them so that the refrigerator will not move.
Turn the adjustable
supports in the arrow
direction until they
touch the floor.
Caster
Adjustable Support
Left
Right
Right
Left
When the left side
of the door tilts down
When the right side
of the door tilts down
Turn the right adjustable support
in the direction of the arrow
to lower the refrigerator.
If the door is still tilted after
adjusting the adjustable support,
place a strong board*1 under
the adjustable support on the
left rear side to make it level.
Turn the left adjustable support
in the direction of the arrow
to lower the refrigerator.
If the door is still tilted after
adjusting the adjustable support,
place a strong board*1 under
the adjustable support on the
right rear side to make it level.
Adjust the supports to
make the refrigerator level.
If the front of the
refrigerator is slightly
raised, the doors are
easier to close.
Prepare for Earthquakes
● It is recommended to pass
2 strong belts through the
handles on the top rear of
the refrigerator and anchor
them to a strong location,
such as a wall or post.
Strong Belts
Bekijk gratis de handleiding van Mitsubishi MR-HS421EX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mitsubishi |
| Model | MR-HS421EX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4766 MB |
