Mitsubishi MFZ-KW25-60VGK handleiding
Handleiding
Je bekijkt pagina 15 van 20
Installation Place and Electrical
Work
When the Air Conditioner Is Not
Going to Be Used for a Long Time
Installation place
Avoid installing the air conditioner in the following places.
• Where there is much machine oil.
• Salty places such as the seaside.
• Where sulde gas is generated such as hot spring, sewage, waste water.
• Where oil is splashed or where the area is lled with oily smoke (such as cook-
ing areas and factories, in which the properties of plastic could be changed
and damaged).
• Where there is high-frequency or wireless equipment.
• Where the air from the outdoor unit air outlet is blocked.
• Where the operation sound or air from the outdoor unit bothers the house next
door.
• Do not install the indoor unit at a place higher than 150 mm.
• Do not operate the air conditioner during interior construction and nishing
work, or while waxing the oor. Before operating the air conditioner, ventilate
the room well after such work is performed. Otherwise, it may cause volatile
elements to adhere inside the air conditioner, resulting in water leakage or
scattering of dew.
Electrical work
• Provide an exclusive circuit for the power supply of the air conditioner.
• Be sure to observe the breaker capacity.
If you have any questions, consult your dealer.
wall, etc.
For the optimum eciency
and to extend the life time of
using, the outdoor unit should
be installed in a well-ventilated
dry place.
3 m or
more
The installation location of the outdoor unit should be at
least 3 m away from the antennas for TV sets, radios,
etc. In areas where the reception is weak, provide
greater space between the outdoor unit and the antenna
of the aected device if operation of the air conditioner
interferes with radio or TV reception.
100 mm
or more
500 mm
or more
1
Set to the highest temperature in manual cool mode,
and operate for 3 to 4 hours. Page 5
• This dries the inside of the unit.
• Moisture in the air conditioner contributes to favorable conditions for
growth of fungi, such as mold.
2
Press
to stop the operation.
3
Do not turn the breaker o except the case of burning
smell, or when performing maintenance or inspection.
The refrigerant leakage cannot be detected, and this
may cause a re.
4
Remove all batteries from the remote controller.
When using the air conditioner again:
1
Clean the air lters. Page 9
2
Check that the air inlet and outlet of the indoor and
outdoor units are not blocked.
3
Check that the earth is connected correctly.
4
Refer to the “Preparation Before Operation”, and follow
the instructions. Page 4
To prevent the eects
of a uorescent lamp,
keep as far apart as
possible.
Inverter-type
uorescent lamp
Keep a space
to prevent the
picture distortion
or the noise.
Radio
TV
Cordless phone
or portable
phone
1 m
or more
1 m
or more
If a power failure occurs or the main power is turned o during operation, “Auto
Restart Function” automatically starts operation in the same mode as the one set
with the remote controller just before the shuto of the main power. When timer is
set, timer setting is cancelled and the unit starts operation when power is resumed.
If you do not want to use this function, please consult the service repre-
sentative because the setting of the unit needs to be changed.
Auto Restart Function
Set temperature : 24°C
Fan speed : Medium
Horizontal vane : Auto
Air outlet : 2 ow
Note:
• The rst 30 minutes of operation is test run. Temperature
control does not work, and fan speed is set to High. The
air outlet selection is set to 2 ow.
Page 6
• In the emergency heating operation, the fan speed gradu-
ally rises to blow out warm air.
Emergency
operation
switch
(E.O SW)
Emergency cooling
operation
Emergency heating
operation
Stop
Operation indicator lamp
When the remote controller cannot be used...
Emergency operation can be activated by pressing the emergency operation
switch (E.O. SW) on the indoor unit.
Each time the E.O. SW is pressed, the operation changes in
the following order:
Emergency Operation
EN-14
Bekijk gratis de handleiding van Mitsubishi MFZ-KW25-60VGK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mitsubishi |
| Model | MFZ-KW25-60VGK |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 4184 MB |
