Handleiding
Je bekijkt pagina 18 van 76
18
ENGLISH
the baby unit. If the connection has not been reestablished within 20 seconds (it has not received
the beacon signal sent by the baby unit), the On/Off and charge LED indicator (4) will ash in red
and green alternately while the parent unit emits a warning beep.
This case, in order to reestablish the link between the two units, check the parent unit is within the
signal range of the baby unit (move the two units closer together and wait for around 5 seconds)
and check that both units are turned on. If the connection is not reestablished, this means the
connection between the parent and baby units has been lost and needs to be reestablished.
5.2.8. Connecting the units (paring)
If the connection between the two units has been lost and it proves impossible to reestablish it
following the instructions set forth above, please follow the steps for paring the parent unit to the
baby unit: press the on / off buttons on both units (1 and 10) simultaneously for 3 seconds, with
both units initially turned off. Both units should connect up automatically.
5.3. GUIDE TO IDENTIFYING AND CORRECTING POTENTIAL PROBLEMS
Problem Possible cause things to do / check
There is no signal in the parent unit · The AC/DC adapter has not been connected to the baby
unit. Connect the adapter.
· The baby unit is off. Turn it on.
· The parent unit is off. Turn it on.
· The parent unit batteries are running low or are already at.
Recharge the units as the battery may be low.
· The parent unit is out of range of the baby unit. Move the
two units closer together and wait for 5 seconds until the link
is reestablished. Pair both units again if necessary (see item
5.2.8.)
· The baby unit is not detecting any sound in the room and
has entered standby mode. The transmission of sound will
recommence when the baby unit detects a sound above the
sensitivity threshold.
The On/Off and charge LED
indicator (4) on the parent unit
ashes in green and red alternately
and emits a three-tone beep. The
sounds captured by the baby unit
cannot be heard.
· The parent unit is out of range of the baby unit. Move the
two units closer together and wait for 5 seconds until the link
is reestablished.
· The connection between the parent and baby units has been
lost. The two units need to be paired again (see item 5.2.8.).
· The baby unit is off. Turn it on.
The baby unit cannot be heard from
the parent unit, but the On/Off and
charge LED indicator (4) is green.
· The volume on the parent unit is turned right down. Raise
the volume by pressing the button (2).
The On/Off and charge LED
indicator (4) is ashing red and
the parent unit beeps every 30
seconds.
· The batteries are running low. Recharge the units as the
battery may be low.
The parent unit emits a high and
strident sound.
· This normally occurs when the parent and baby units are too
close together. Move the units further apart.
Bekijk gratis de handleiding van Miniland Digitalk Easy 89474, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miniland |
| Model | Digitalk Easy 89474 |
| Categorie | Babyfoon |
| Taal | Nederlands |
| Grootte | 7526 MB |
