Miele G 5811 SC Active Plus handleiding
Handleiding
Je bekijkt pagina 74 van 88
Problem solving guide
74
Door release
Problem Cause and remedy
Fault number 33 ap-
pears in the time display.
The door does not open automatically.
There may be a technical fault.
Switch the dishwasher off.
Open the door manually (see “Before using for the
first time – Opening the door”) and switch the dish-
washer back on again.
If the same fault message appears again, call the
Miele Customer Service Department.
The door locking pins do not retract after the door is
opened.
There may be a technical fault.
Switch the dishwasher back on.
If the same fault message appears again, call the
Miele Customer Service Department.
Water inlet fault
Problem Cause and remedy
The / indicator
light flashes on and off.
and appear altern-
ately on the time display.
The stopcock is closed.
Open the stopcock fully.
The dishwasher stops
during a programme.
The /indicator
light is flashing.
The fault number or
appears in the time
display.
Before rectifying the problem:
Switch the dishwasher off with the button.
There is a water inlet fault.
Open the stopcock fully and start the programme
again.
Clean the filter in the water inlet (see the “Cleaning
and care – Cleaning the water inlet filter”).
The water connection pressure is lower than 50kPa.
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water drain-
age (see “Installation – Water drainage”).
If the fault message is displayed again, there may be a
technical fault with the flowmeter.
Call the Miele Customer Service Department.
Bekijk gratis de handleiding van Miele G 5811 SC Active Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miele |
| Model | G 5811 SC Active Plus |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 9229 MB |
