Metra 99-9123 handleiding
Handleiding
Je bekijkt pagina 2 van 2
1
2
Attach the Faceplate to the Snap-in Bracket.
Slide the aftermarket head unit into the kit and
secure with shaft nuts.
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the
factory radio knobs and shaft nuts. Unclip the factory faceplate. Insert a flat-blade screwdriver
into the shaft wells and push in on the side springs. Pull the factory radio out and disconnect
the wiring.
Slide the aftermarket head unit into the Snap-in Bracket. If the shafts of the head unit do not
pass easily through the kit, cut and remove the upper-shaft tabs from the shaft openings. ("A")
3 4
1
2
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
5
Re-connect the battery terminal and test the unit for proper operation. Snap the head unit/kit
assembly into the sub-dash.
"A"
ALL VEHICLES
Bekijk gratis de handleiding van Metra 99-9123, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-9123 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 554 MB |
