Metra 99-7386B handleiding
Handleiding
Je bekijkt pagina 7 van 12
REV. 12/18/24 INST99-7386B
7
PROGRAMMING THE AXXESS INTERFACE AND CLIMATE DISPLAY
Programming the Axxess interface:
1. For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED,
2. Start the vehicle. The LED will initially turn on solid Green, then turn off for a few seconds
while it auto detects the radio installed.
3. The LED will then flash Red up to (24) times indicating which radio is connected to the
interface, and then turn off for a couple of seconds. Pay close attention to how many Red
flashes there are. This will help in troubleshooting, if need be. Refer to the LED feedback
section for more information.
4. After a couple seconds the LED will turn on solid Red while the interface auto detects the
vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
5. Once the vehicle has been auto detected by the interface, the LED will turn on solid Green,
and the radio will come back on, indicating programming was successful.
6. Test the steering wheel controls for proper operation. Refer to the “Steering wheel control
settings” for customizing the buttons, if so desired.
Programming the climate display:
7. Turn the parking lights on.
8. Turn the vehicles light dimmer all the way down, then all the way up.
9. Turn the lights off.
10. Test all functions of the installation for proper operation, before reassembling the dash.
11.
If the interface fails to function, refer to “Troubleshooting”, “Resetting the Axxess interface”.
Note: The LED will turn on solid Green for a moment, and then turn off under normal operation
after the key has been cycled.
Final Assembly
1. Remove (2) Phillips screws securing the factory hazard climate control panel.
2. Secure the
climate display
included with the kit to the dash using the factory screws.
3. Secure the radio assembly to the dash using the factory screws.
4. Clip the factory vents to the dash to complete the installation.
FINAL ASSEMBLY
Bekijk gratis de handleiding van Metra 99-7386B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-7386B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1376 MB |
