Metra 99-5842T handleiding

16 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 9 van 16
REV. 12/9/2022 INST99-5842
9
Attention! If the interface loses power for any reason, the following steps will
need to be performed again.
1. Refer to step 2 from the “Installation” section.
2. Program the kit:
a. Place the vehicle into the start/run position.
b. Once the touchscreen display loads up, select the vehicle type.
c. Wait until the radio comes on, and the touchscreen display shows
“SWC Configured”. This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn’t come on within
3 minutes, and/or the touchscreen display does not show “SWC Configured”, turn the vehicle
off and disconnect the
5842 harnesses
from port “A” in the touchscreen display. Check all
the connections, reconnect the harness into the touchscreen display, and then try again.
3. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.
4. Test all functions of the installation for proper operation, before reassembling the dash.
PROGRAMMING
1. Secure the radio assembly into the dash using the factory hardware removed in
dash disassembly.
2. Snap the
radio trim panel with touchscreen display
over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
SYNC (4.2-inch display screen models only):
If the vehicle is equipped with SYNC and a 4.2” display screen, the 99-5842 can retain the
SYNC feature.
1. Change the source of the radio to AUX-IN.
2. Press the “Info” button on the touchscreen display to enter the SYNC menu.
3. Press the “HVAC” button to get back to the main menu.
EXTRA FEATURES
FINAL ASSEMBLY

Bekijk gratis de handleiding van Metra 99-5842T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkMetra
Model99-5842T
CategorieNiet gecategoriseerd
TaalNederlands
Grootte2032 MB