Metra 99-5840CH handleiding
Handleiding
Je bekijkt pagina 11 van 16
11
REV. 5/29/25 INST99-5840CH
11
1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured.
This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn’t come on within
3 minutes, and/or the touchscreen display does not show SWC Configured, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
4. Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
5. Test all functions of the installation for proper operation, before reassembling the dash.
1. Connect the USB cable attached to the radio trim panel with touchscreen display, to the
USB port in the back of the radio, if applicable.
2. Secure the completed assembly into the upper dash using the factory hardware removed in
step 12 of dash disassembly.
3. Snap the radio trim panel with touchscreen display over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
PROGRAMMING
FINAL ASSEMBLY
Bekijk gratis de handleiding van Metra 99-5840CH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-5840CH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2040 MB |
