Metra 99-3028S handleiding

20 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 14 van 20
386.257.1187
|
MetraOnline.com
1414
ADJUSTMENTS
Chime level adjustment:
1. With the vehicle on, turn it off and leave the keys in ignition. Open the driver’s door; chimes
will be heard.
2. Wait 10 seconds, and then with a small flat-blade screwdriver, turn the potentiometer
clockwise to raise the chime level; counterclockwise to lower the chime level.
3. When the chime is at a desired level, remove the keys from the ignition. This will lock the
chime volume at its current level.
OnStar level adjustment:
1. Press the OnStar button to activate it.
2. While OnStar is speaking, press the VOLUME-UP or VOLUME-DOWN button on the steering
wheel to raise or lower the OnStar level.
3. If the vehicle doesn’t come equipped with steering wheel controls, locate the Black/Yellow
wire on the 3028 harness.
4. While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level is set,
it will stay at that level until the Black/Yellow wire is tapped to ground again.
For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED.
1. Start the vehicle.
2. Connect the 3028 harness to the wiring harness in the vehicle.
3.
The LED will initially turn on solid Green, then turn off for a few seconds while it auto detects
the radio installed.
4. After a couple seconds the LED will turn on solid Red while the interface auto detects the
vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
5. Once the vehicle has been auto detected by the interface, the LED will turn on solid Green,
and the radio will come back on, indicating programming was successful.
Programming the climate display:
6. Ensure that the vehicle is still running.
7. Adjust the fan speed on the climate control all the way up, then all the way down.
8. Test all functions of the installation for proper operation, before reassembling the dash.
9. If the interface fails to function, refer to the Troubleshooting section.
Note: The LED will turn on solid Green for a moment, and then turn off under normal operation
after the key has been cycled.
PROGRAMMING

Bekijk gratis de handleiding van Metra 99-3028S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkMetra
Model99-3028S
CategorieNiet gecategoriseerd
TaalNederlands
Grootte2218 MB