Metra 99-3028S handleiding
Handleiding
Je bekijkt pagina 13 van 20
REV. 12/18/24 INST99-3028S
1313
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the 3028 harness, into the
Axxess interface.
2. Connect the climate control harness to the radio trim panel, then to the wiring harness in
the vehicle.
3. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
Attention! Do not connect the 3028 harness to the wiring harness in the vehicle just yet.
I N STALL AT I O N
CONNECTIONS (CONT.)
• The Black/Yellow wire is used for OnStar level adjustment for models that do not come
equipped with steering wheel controls. Refer to the OnStar level Adjustment section for
further instructions.
• If retaining the factory AUX-IN jack is desired, connect the Red and White RCA jacks to the
audio AUX-IN jacks from the aftermarket radio.
Note:
a) The jack can only be used if it is a single jack.
b) If the jack has a USB port as well, neither can be retained.
Note: The relay attached to the 3028 harness is only for audible turn signal clicks. No extra steps
are required to retain this feature, so leave the relay as-is.
DIN jack:
The DIN jack is to be used with the optional AX-LCD (sold separately) to retain the
personalization menu.
Continue to Installation
Bekijk gratis de handleiding van Metra 99-3028S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-3028S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2218 MB |
