Metra 99-3012G handleiding
Handleiding
Je bekijkt pagina 7 van 16
7
REV. 6/7/2022 INST99-3012G
PROGRAMMING THE INTERFACE (CONT.)
4. Once the interface has been programmed the L.E.D. will turn solid Green, then the radio will
come back on, indicating programming was successful.
5. Test all functions of the installation for proper operation, before reassembling the dash.
6. If the interface fails to function, refer to “Troubleshooting”, “Resetting the Axxess interface”.
Note: The L.E.D. will turn on solid Green for a moment, and then turn off under normal operation
after the key has been cycled.
TROUBLESHOOTING
FINAL ASSEMBLY
ADJUSTING THE INTERFACE
ADJUSTING THE INTERFACE
(CONT.)
Resetting the Axxess interface
1. The Blue reset button is located inside the Axxess interface, between the two connectors.
The button is accessible outside the Axxess interface, no need to open the Axxess interface.
2. Press and hold the reset button for two seconds, then let go to reset the Axxess interface.
3. Refer to “Programming the Axxess Interface” from this point.
1. Secure the radio assembly to the dash using the factory screws.
2. Reassemble the dash in reverse order of disassembly using the 99-3012G radio trim panel to
complete the installation.
Chime level adjustment:
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver’s door;
chimes will be heard.
• Wait 10 seconds, and then with a small flat-blade screwdriver, turn the potentiometer
clockwise to raise the chime level; counterclockwise to lower the chime level.
• When the chime is at a desired level, remove the keys from the ignition. This will lock the
chime volume at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME-UP or VOLUME-DOWN button on the steering
wheel to raise or lower the OnStar level.
• If the vehicle doesn’t come equipped with steering wheel controls, locate the Black/Yellow
wire on the 3012 harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level is set,
it will stay at that level until the Black/Yellow wire is tapped to ground again
.
Bekijk gratis de handleiding van Metra 99-3012G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-3012G |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1914 MB |
