Metra 95-7640B handleiding
Handleiding
Je bekijkt pagina 17 van 48
17
REV. 6/6/24 INST95-7640B
INSTALLATION
Attention! It is highly advisable to read the following steps beforehand, to ensure a clear understanding of what
is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
1. Refer to your aftermarket radios installation manual for how to match the radio’s harness to the axxess
interface harness. Refer to your vehicle specific diagram. Make sure you are using the correct diagram.
2. With the aftermarket radio harness wired up, plug in the 16 pin connector (LD-2NAVAMP Harness) into plug B
of the HVAC Screen.
3. Plug in the 2 pin plug from the Main Harness into the HVAC Screen
Note: If the touchscreen display does not load up, or the radio doesn’t come on within (3) minutes, and/or the
touchscreen display does not show SWC Configured, check all connections, then reset the interface and try again.
4.
Plug in the 24 pin plug from the MAIN HARNESS into Port “A” of the HVAC touchscreen display.
Important: Do not plug in the carside connectors (OE radio plugs) until step 1 of the Programing Section.
5. Port F is an updater port used for updating the firmware using the Axxess Updater Program.
6. Secure the touchscreen to the dash using the factory screws.
Continue to Programming
A
F
B
C
E
(Figure B)
(Figure A)
Bekijk gratis de handleiding van Metra 95-7640B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 95-7640B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7030 MB |
