MDT BE-TAS55T4.01 handleiding
Handleiding
Je bekijkt pagina 75 van 89
Technical Manual – Push Button Smart 55/63
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
Phone: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
75
75
Each LED can either react to any external object, such as the status of an actuator, an internal object
or keystroke. In addition, an LED can also react to an external or internal object and key activation.
With this setting, the settings in menu LED 1-4 refer to the control of the LED via the object. In this
case, the behaviour of key activation is set globally for all LEDs and is described in menu 4.7.1 LED
basic settings. The behaviour for key activation has priority.
If the setting LED reacts to "internal object" is selected, the object number to which the LED is to be
linked is selected.
If, for example, single-button 1 is set to “Switch” – “Toggle” and the LED is to respond to the object
"value for toggle", the object number "1" has to be entered. In this case the status LED would be
switched on if the object has a 1 and switched off if the object has a 0.
With the setting LED reacts to "external object", different DPTs can be selected.
If the LED reacts to “1Bit Switch”, the values for ON and OFF can be parameterised.
If the LED reacts to the DPT 1Byte Percent value, the value can be specified here from which the LED
is considered to be ON. For example, if a pre-set value of 50% is entered, this means that the LED is
switched on from a value of 50% and switched off at values <50%.
If the LED reacts to “1Byte decimal value”, the following colours apply to the following values
Object value: 0 = black, 1 = white, 2 = red, 3 = green, 4 = blue, 5 = yellow, 6 = pink, 7 = cyan
Each LED can assume different colours and behaviour for Day and Night operation. It switches
depending on the object 72 - Day/Night.
The following table shows the available communication objects:
Number
Name
Length
Usage
52
LED 1 – Switch,
Percent value,
Decimal value
1 Bit
1 Byte
Control of the LED.
Object is only shown if LED reacts to external
object
Table 70: Communication object – LED
Bekijk gratis de handleiding van MDT BE-TAS55T4.01, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MDT |
| Model | BE-TAS55T4.01 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20559 MB |
