Master-Bilt QS2 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104/ 104

Afdrukken

Je bekijkt pagina 29 van 104

29

8/22 Rev. R 132617 ©2022 Refrigerated Solutions Group. All rights reserved.

WALK-IN INSTALLATION

Fi

gure 13

SEALING THE JUNCTURE OF WALLS TO BUILDING FLOOR

Apply a generous amount of NSF approved sealant to achieve a vapor seal between the bottom edge of all wall,

corner, door and partition panels and the building floor. The sealant must be applied to both inner and outer edges

of all perimeter walls and to both edges of partition walls where they meet the building floor. Make certain that the

sealant produces a continuous, air-tight seal, without gaps, and that special care is taken to seal around the

shimming material.

After the sealant has had an opportunity to set up, trim away all excess sealant flush with the edges of the walls.

Touch up any areas where the sealant is not making a perfect seal (Figure 8).

COVE MOLDING

To comply with the requirements of Standard No. 7, National Sanitation Foundation, a cove molding with a minimum

radius of 1/4” must be applied to cover the juncture of the walk-in walls and the building floor. For with floor models

cove molding is required on exterior walls only.

Cove molding and adhesive for application are not normally provided. They are readily available at most building

materials suppliers.

Before applying cove molding, make final inspection of the area that will be covered with the molding to make sure

that the sealant is intact and making perfect vapor seal. If not, add sealant as required. Read and follow the

instructions prepared by the manufacturer of the cove molding and the adhesive before proceeding with the

installation (Figure 13).

If tile and grout are employed as floor material and, if base title is intended to produce the cove required, make sure

that the inside radius of the base tile is at least 1/4”.

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104/ 104

Bekijk gratis de handleiding van Master-Bilt QS2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Koelkast