Master-Bilt QS2 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104/ 104

Afdrukken

Je bekijkt pagina 17 van 104

17

8/22 Rev. R 132617 ©2022 Refrigerated Solutions Group. All rights reserved.

WALK-IN INSTALLATION

ALTERNATE SHIMMING METHOD FOR 1’’ VINYL SCREED

If the surface that the vinyl screed will occupy is level, except for an occasional low point, the screed may be

secured directly to the building floor and compensation for the low points may be achieved by shimming the support

shoulders on the inside of the screed.

When employing this method, the low points should be marked on the building floor in the vicinity of the drawn

outline for reference. After the screed has been sealed and secured, leveling may proceed with special attention

being focused in the areas marked as being low points.

Vinyl floor tile is often chosen as shimming material and strips (5/8’’ wide maximum) are cut and placed on top the

supporting shoulders of the screed to provide a level surface for the wall sections to rest upon. Strips of tape should

be applied to hold the shimming material in place (Figure 5).

IMPORTANT! Shimming the support shoulders on the inside of the screed is ideally suited for minor irregularities

on the building floor and has the advantage of complete screed-to-floor contact over the entire perimeter of the

assembly. IT IS NOT RECOMMENDED, HOWEVER, FOR EXTREMELY IRREGULAR BUILDING FLOORS.

Excessively thick shimming material on the support shoulders may elevate the wall panels to a point where the

effectiveness of the uppermost screed sealing flanges would be compromised. Shimming thickness of more than

3/4’’ should be avoided! If shimming the support shoulders of the screed is selected, the entire procedure, as

described, must be followed explicitly to ensure squareness and levelness over the entire screed assembly.

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104/ 104

Bekijk gratis de handleiding van Master-Bilt QS2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Koelkast