Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

14 Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual

Side panel

The P3 PowerPort 500 IP Rental has a pressure equalization valve on the side of the device (see

illustration). Check this valve visually from time to time. If it appears to be dirty, consult Martin Service for

possible replacement

Installing

Read the ‘Safety Information’ section starting on page 5 before installing, applying power to or operating

the device.

The P3 PowerPort 500 IP Rental is designed to be installed in a 19-inch rack, on a rigging truss or on a

flat surface in any orientation.

Rack mounting

To mount one single P3 PowerPort 500 IP Rental in a 19-inch rack:

1. Fasten one short rack ear (supplied) and one long rack ear (supplied) to the front of the device using

the supplied screws. Do not fasten the supplied safety cable attachment bracket to the device.

2. Fasten the device into the rack. Bear in mind the need for good ventilation and the possible need for

fan cooling.

To mount two P3 PowerPort 500 IP Rental

devices side-by-side in a 19-inch rack:

1. See illustrations on right. Fasten the two

devices together by fastening the two

supplied coupling plates to the devices,

one plate on the front and one plate on

the rear, using the supplied screws.

2. Fasten the two supplied short rack

mounting ears to the devices using the

supplied screws. Note that you can

rackmount the devices with the

connections panel at the front or at the

rear of the rack, but if you mount them at

the front the status LEDs and Test/Reset

button will be less accessible. Do not

fasten the supplied safety cable

attachment bracket to the devices.

3. Fasten the two devices into the rack.

Bear in mind the need for good

ventilation and the possible need for fan

cooling.

Truss mounting

When installing the P3 PowerPort 500 IP Rental on a rigging truss, use half-coupler type rigging clamps

(see Figure 1 on page 12) that completely encircle the truss chord. Rigging clamps must be in perfect

condition and approved for the weight that they will support.

You can install the P3 PowerPort 500 IP Rental on a rigging truss either mounted horizontally or hanging

vertically.

Pressure

equalization valve

Rigging

bracket

Short rack

mounting ear

Coupling plate for side-

by-side rack mounting

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.