Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

10 Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual

connector must be TOP (True Outdoor Protection) type. See the P3 PowerPort product pages on the

Martin website at www.martin.com for details of cables and connectors available from Martin.

No input connector is required for the P3 PowerPort 500 IP Install power input cable, as this device is

designed to be hard-wired using internal terminals during installation.

Accessories and related items

Martin can supply a comprehensive range of cables, connectors, rigging hardware and other accessories

for the products in Martin P3 systems. The accessories listed in the Specifications sections of the related

areas of the Martin website at www.martin.com give details. Your Martin supplier will also be happy to help

if you would like assistance with assessing your needs and ordering.

Status LEDs and switchable options

The three P3 PowerPort devices covered by this manual have the following features:

Status LEDs

The status LEDs light when a signal is present and flash when data is being received or transmitted. They

also give device status information. See ‘Status LEDs and Test/Reset button’ on page 22 for more details.

Switches

The two switches on or inside the device have the following functions:

• FRONT PANEL ON/OFF – disables all the status LEDs and disables the Test/Reset button (see

‘Status LEDs and Test/Reset button’ on page 22). Setting this switch to OFF reduces the visibility of

the device in the installation and protects from accidental resets or tampering.

• POWER CONTROL/FULL/HALF – offers three settings that apply to all connected compatible Martin

Creative LED fixtures:

- FULL forces all fixtures to run in full-power mode, overriding any power mode commands from the

P3 System Controller, Art-Net controller, sACN controller or RDM controller.

- HALF forces all fixtures to run in half- or low-power mode, overriding any power mode commands

from the P3 System Controller, Art-Net controller, sACN controller or RDM controller.

- CONTROL allows the P3 System Controller, Art-Net controller, sACN controller or RDM controller

to set the fixtures’ power modes.

Setting fixtures to low power can be useful for nighttime or TV studio applications, for example, where

full power is not needed or may be undesirable. The HALF setting also lets you connect a higher

number of fixtures to the hybrid output, meaning that an installation will require fewer P3 PowerPort

devices.

Note that when the POWER CONTROL switch is set to FULL or HALF, it is not possible to adjust the

power mode from the P3 System Controller, Art-Net controller, sACN controller or RDM controller.

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.