Martin Logan Dynamo 12 handleiding
Handleiding
Je bekijkt pagina 9 van 46
9
App Controls:
The following controls can be accessed via the MartinLogan subwoofer control app. Use the camera on
your iOS or Android device to scan the QR code on the back of the subwoofer (also available on the
packaging and QuickStart Guide) to download the app.
• Level: -40 to 12dB (Min-Max)
• Low-Pass Filter (Frequency): 35–120Hz (1° Increments)
• Low-Pass Filter (Order): Bypass, Third, Fourth
• Phase: 0–180° (1° Increments)
• Phase (Polarity): Normal, Inverted
• DSP Preset Listening Modes: Movie, Music, Night
• 20–30Hz Level: ±10dB
• Anthem Room Correction (ARC Genesis): On, Off
• Tone Sweep (120-20Hz): On, Off, Pause (Frequency)
ConTrols
Backplate Controls:
The following controls can be accessed on the back of the subwoofer:
• Level: Interactive LED Backlit Knob, Min–Max
• Tone Sweep: Sweep Start and Pause (with status light)
• Power Mode: On, 12v Trigger, Auto
• Wireless Audio Pairing Button (for included MartinLogan wireless transmitter)
Level/Volume (on backplate or via MartinLogan Subwoofer Control App)
Most AV Receivers or Processors have some form of auto-setup/calibration feature that will typically set the
levels of the speakers and subwoofer(s). If using this feature, you can set the volume knob on the subwoofer
to roughly the halfway point and let the system calibrate the level for you. If you desire more or less bass
than what it configures for you, simply adjust the subwoofer volume control (or the subwoofer level control in
your electronics) to achieve your preferred sound.
Tone Sweep (on backplate or via MartinLogan Subwoofer Control App)
The tone sweep feature is a useful tool for identifying rattles in your room. Initiating the sweep and pausing
it at frequencies that cause things in your room to rattle (like artwork, picture frames, furniture etc.) will help
you identify these rattles and address them as you feel appropriate. To initiate the tone sweep you can use
the MartinLogan Subwoofer Control App, or the buttons on the back of the subwoofer as described below:
1. Press the “Tone Sweep” button for 1 second to start the tone sweep. The “Sweep Status” LED will turn
white. Use the subwoofer level control as needed.
2. Press the “Tone Sweep” button again to hold the sweep at a specific frequency. The “Sweep Status” LED
will turn red while the sweep is holding.
3. Press the “Tone Sweep” button again to stop the sweep. The “Sweep Status” LED will turn off.
4. Repeat these steps as needed.
Note: The tone will turn off after 1 minute from the last button press.
Bekijk gratis de handleiding van Martin Logan Dynamo 12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Logan |
| Model | Dynamo 12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3307 MB |
